Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10/GMC S15-Sonoma: Problems & Solutions 
2018 messages, Last post on Oct 17, 2006 at 9:12 PM
You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram
|
|
|---|---|
| Hay me again, I have another problem with my 1997 GMC Sonoma 4.3 Liter auto. I replaced the manifold intake gasket which went just fine, drove the truck did good but sounded like it was a notch out of time,it was hard to start then, however I decided to move the distributor a notch back, now it won't crank at all the dash lights such as the oil light and check engine lights or the fuel pump will not work I have checked all the grounds on it and everything seems to be hooked up HELP anybody who may a solution other than junking it which I'm very close to doing | |
|
|
|
we have a 1987 S15 with a 2.2 standard 4spd. Great little truck, it's mileage is at 460,000 KM and going strong. The problem we have is that we have lost our low wiper speed. (we do not have the intermittent feature)The question is, do we replace the switch, or is it the wiper motor? anyone else have this problem? We also are experiencing the chirping noise that others have mentioned. It can be annoying, is it the throw out bearing,?? is that hard to grease? My husband is able to fix most things, so we don't like taking the truck to a repair shop. |
|
|
|
|
we have a 1987 S15 with a 2.2 standard 4spd. Great little truck, it's mileage is at 460,000 and going strong. The problem we have is that we have lost our low wiper speed. (we do not have the intermittent feature)The question is, do we replace the switch, or is it the wiper motor? anyone else have this problem? We also are experiencing the chirping noise that others have mentioned. It can be annoying, is it the throuw out bearing,?? is that hard to grease? My husband is able to fix most things, so we don't like taking the truck to a repair shop. We would like to add that we are very happy with our little truck! |
|
|
Replying to: Mr_Shiftright (Oct 18, 2005 8:20 pm) 
|
|
|
|
|
Replying to: jasleep (Nov 10, 2005 5:16 pm)
|
|
|
Hello, I have a 02 sonoma. I bought a reese hitch years ago. I dug it out, but can't seem to see how it will work. Any ideas? The hitch is a Type 3. 750-500 tounge weight. It may just be to big. I checked reese. All they showed were diagrams on assembly. Hope there's help. Thanks Crabs.
|
|
I am thinking about taking out my 2.5 4cyl and dropping in a 305 or 350. What all would I have to do to make it fit. Do I need to make it carburated or can I use fuel injection. Also would the stock trans and rear end work
|
|
|
|
|
Replying to: crabs (Nov 10, 2005 7:27 pm) |
|
|
|
|
Replying to: mattv1 (Nov 10, 2005 9:19 pm) |
|
|
|
| The service engine soon light comes on sometimes (not evereday) during highway driving, ussualy going faster than 55MHP, on my 1995 Chevy S10. But when i shut down the engine, and restart it again the light is off. Can anybody tell me what could be happening? | |
You are here:
Forums
Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10/GMC S15-Sonoma: Problems & Solutions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2004 Chevrolet S-10
2004 GMC Sonoma
1990 GMC S-15
Browse by Board
Browse by Topic
Today's Chats
