Sign In Join 



Chevy Silverado/GMC Sierra - Owners hangout - READ ONLY

5688 messages,  Last post on Oct 17, 2006 at 8:34 PM

You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram

What is this discussion about? Chevrolet Silverado 1500, Chevrolet Silverado 2500, Chevrolet Silverado 3500, GMC Sierra 1500, GMC Sierra 2500, GMC Sierra 3500, Truck


Messages Page 511 of 570
1
...
508
509
510
511
512
513
514
...
570
Prev
Next
Last
Go To Msg #
Search This Discussion

#5094 of 5688
Re: 1997 silverado dies on acceleration [oshawa] by minniescar
Jul 21, 2005 (9:27 am)

Replying to: oshawa (Jul 21, 2005 7:30 am)

Would the MAF not throw out any trouble codes if it was dirty and getting mixed signals?
#5095 of 5688
Re: 1997 silverado dies on acceleration [minniescar] by oshawa
Jul 21, 2005 (11:18 am)

Replying to: minniescar (Jul 21, 2005 9:27 am)

What I think is going on is the MAF sensor is dirty, the engine doesn't see anything wrong with this so there probably wouldn't be any trouble codes. When you accelerate your MAF is probably sending a signal to run the engine at an idle speed as the MAF is not reading as much air going by because it is dirty. Cleaning it takes no time at all...just follow the proper steps.
 
Good luck.
#5096 of 5688
Re: 1997 silverado dies on acceleration [oshawa] by oshawa
Jul 21, 2005 (11:24 am)

Replying to: oshawa (Jul 21, 2005 11:18 am)

I know it may be hard to believe, but this little sensor is very tempermental....I didn't believe it at first.
 
Your symptoms are pointing to a dirty MAF. get a good can of carb cleaner, thats all you need to use to clean it as it is alcohol based and evaporates very fast.
#5097 of 5688
Re: 1997 silverado dies on acceleration [oshawa] by minniescar
Jul 21, 2005 (11:59 am)

Replying to: oshawa (Jul 21, 2005 11:18 am)

ill try it this evening hell ill try anything , ive been sitting under the hood of this truck every eveing for 5 days now and nothing has panned out.........
 
 On a side note something i read on the site i was reffered to on how to clean the sensor got me to thinking about something. My truck has 198K on its odometer but the engine and injection system where completely replaced 20k ago ( original engone was a 305 now its a 350 ). Prior to me purchasing it a freind of mine had all this work done , he also had the transmission rebuilt 3 times, thats how i got the truck. The fourth time the tranny went out he parked the truck in the yard he said he wasnt sinking another dime into the truck and he went out and bought a brand new ford F250. This buddy of mine hauls scrap metal and every bpdy who knew him always assumed the tranny going out was due to him over loading the truck then slapping a trailer behind it , but maybe not, the site that tells how to clean out the MAF sensor mentions how if the Maf sensor is reading wrong it can tear up a transmission since the computer doesnt know when to shift, i wonder if thats the case.
 
needless to say I bought the truck with the tranny messed up and i had it fixed after my buddy gave up on it.
#5098 of 5688
CB installation by rich37
Jul 21, 2005 (12:58 pm)
Just bought a GMC 2004 1500 Sierra and would like to install my CB However, this truck has buckets and a center console that goes right up to the dash. Not much room to put the CB! I also have a trailer brake controller to install, but I could just leave this unit on top of the console when I use it (I have the controller on a disconnect as I use it in several trucks) How have you installed your CB with this cab configuration?? Thanks
#5099 of 5688
Re: 1997 silverado dies on acceleration [minniescar] by minniescar
Jul 22, 2005 (4:45 am)

Replying to: minniescar (Jul 21, 2005 11:59 am)

I tried cleaning the MAF sensor last night and i got no results, the sensor itself actually looked clean to begin with but i cleaned it anyway, the engine still dies on acceleration after the cleaning. I told a buddy of mine i would take it to a shop to have it looked at but the only problem is i would have to hire a wrecker to tow it there, anyone got any ideas
#5100 of 5688
Re: 1997 silverado dies on acceleration [minniescar] by oshawa
Jul 22, 2005 (5:33 am)

Replying to: minniescar (Jul 22, 2005 4:45 am)

The only other thing I can think of is EGR system. The valve could be either stuck open or stuck closed.
 
Can you drive the truck fine while the engine is cold or does it sputter still?
 
I wouldn't take it to a shop yet. We'll figure this problem out.
#5101 of 5688
Re: Geo9........ Canada [rayt2] by txyank1
Jul 22, 2005 (6:23 am)

Replying to: rayt2 (Jul 20, 2005 8:14 am)

Or let the Government pay you for not planting whatever it is we have enough of right now.
#5102 of 5688
Aftermarket Grills by stoneg
Jul 22, 2005 (6:29 am)
I am looking to replace my grill on my 05 2500hd with a Denali grill.
I have shopped everywhere, including the dealership. Some of the ones I am finding are close, but no cigar. Putco makes one, but the area inside of the "C" in GMC is solid chrome, instead of black like the Denali. I would like it to look clean, and not a cheesy knock off. Anyone replaced theirs yet? Any ideas?
Thanks,
Stone G
#5103 of 5688
TXYANK by geo9
Jul 22, 2005 (7:24 am)
Hey Mister.....................Gonna be heading out to your old stomping
grounds in the southern tier NY for a snowplow meet and greet in Aug.
at the local Hooters...................
The happy snow will be here soon enough !
 
Hows the Avalanche treating ya?.....................................

Messages Page 511 of 570
1
...
508
509
510
511
512
513
514
...
570
Prev
Next
Last
Go To Msg #
Search This Discussion

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement