Last post on Sep 11, 2012 at 4:19 PM
You are in the Saturn S-Series
What is this discussion about?
Saturn S-Series, Sedan
#1410 of 1418 Re: 1997 Saturn SC2 (AT) transmission problems HELP PLZ! [nate91304]
Dec 15, 2010 (5:11 pm)
sounds like transmission shift sensors have car checked with a computer try auto zone they will put it on your car and tell u why your check engine light is on
#1411 of 1418 Dangerous Dumping Fuel 99-2000 SL 2
Aug 03, 2011 (1:18 pm)
I have a 2000 SL2 that has an issue with the vent line in the tank and return line from the engine. It makes it makes it very hard to put fuel in the tank and whenever it is running with the cap on the back pressure pumps gas out of the return valve next to the filler tube. The amount of gas it dumps is phenomenal so we have started driving with the gas cap off. We have replaced the fuel pump module and the computer with no resolve. There is a gas vent control box on top of the tank which no one seems to know anything about. Should have been a recall on this but the welded return line does not cover this type of behavior. Anyone have any suggestions?
Aug 07, 2011 (11:21 am)
hello, i have a '02 sl2 twin cam w/100k miles. i began having start problems intermitently. fuel pump not working so it was replaced. It worked for two days then wouldn't start. The fuse is good, relay checked good, jumpered the pump at relay and it works. relay doesn't seem to receive power to energize it. also the fuel gauge that had worked before now doesn't read either. any ideas?
#1414 of 1418 Re: fuel pump [lizardking2]
Aug 07, 2011 (2:35 pm)
I have '02 SL1. I have not studied the circuitry yet, but it sounds like possible ignition switch problem. One of the lines may have gone bad so no power is applied to sections of the fuse panel(s).
#1415 of 1418 1994 SL2 No compression in #2 Cylinder
Aug 03, 2012 (2:39 pm)
Hi! I have a 1994 Saturn SL2 that I use for commuting to my job 300 miles from home (drive 600 miles/week). Odometer reads 220k miles. Normally, I drive 65 mph on the freeway using cruise control. Until yesterday, the car ran like a dream - very smooth, easily maintained speed and temperature, got great gas mileage - up to 50 mpg (with a tail wind!!).
Yesterday, while climbing a hill, with A/C on, the engine suddenly began struggling to maintain speed and began to heat up. I turned off the A/C and pulled over to find the engine running very rough, but without the load, the temp returned to normal. I continued for another 35 miles, but noticed the engine was struggling, so shut it down to begin testing. Notably, exhaust was not particularly smokey.
I pulled spark plug wires one at a time and found that the #2 cylinder was not contributing - spark was there, but roughness did not change when spark plug wire was pulled. After a 165 mile tow, this morning I ran a compression test to find #1, 3, and 4 running at appx 180 psi. #2 at 0 psi. Spark plugs #1,3, and 4 had a white-ish buildup on the ground electrode, and buildup on #2 appears to have broken off (maybe stuck in valve?)
I reason that I may have a stuck valve, or burned valve. I rule out broken rings due to clean exhaust. Maybe a broken piston?
I assume the next step is to pull the valve cover, but have never done this on this vehicle. Any guidance and or discussion would be appreciated. Any steps to take that would narrow down the possibilties?
Thank you - RenoMike
#1416 of 1418 Re: 1994 SL2 No compression in #2 Cylinder [renomike]
Aug 03, 2012 (3:22 pm)
When there is 0 psi reading on compression test of #2 cylinder, cyl #2 is completely vented. A burnt valve would still have some compression. The rough driving sounds to the result of operating on 3 cylinders. Not sure why the coolant temperature rose on you, probably normal for slow grind up the hill with load. My guess is that the electrode of spark plug failed and the broken electrode served as hard debris that may have scored up your cylinders and vented the cylinder compression that way. Search Richpin videos on Youtube for removing valve cover. Easy job, but that only helps you confirm valve motion. I am afraid the damage could be in your block, piston, its rings after driving so far with debris in cylinder. Good would be the electrode hung up in your valves to mess up the head instead of the bore. If your plugs are original, that would suggest failure of a plug from excessive age/use. Major engine job either way I am afraid.
#1417 of 1418 Re: 1994 SL2 No compression in #2 Cylinder [renomike]
Aug 03, 2012 (4:25 pm)
You may want to pull the oil pan off. This won't fix anything but it may give you some clues. You may find some debris in the bottom of the pan or with a good flash light you may be able to see the cylinder or piston from below.
Sep 11, 2012 (4:19 pm)
I am getting codes 11, 25, 71, 77 can anyone help me with what there are and how best to get them fixed?