You are here: Forums Sedans Chevrolet (Geo) Prizm Chevrolet (Geo) Prizm

Chevrolet (Geo) Prizm

1322 messages,  Last post on Dec 06, 2009 at 2:12 PM

You are in the Chevrolet (Geo) Prizm Forum. Your Hosts are pat & karens

What is this discussion about? Chevrolet Prizm, Geo Prizm, Sedan

Messages Page 130 of 133 1 ... 127 128 129 130 131 132 133 Prev Next Last

Go To Msg # Search This Discussion

#1286 of 1322 lights on gear shift by meeko May 10, 2009 (12:39 pm)
I have a 1998 Chevy prism. Lights on gear shift did not go on at night when I turned on my headlights. Pulled onto a sloped driveway put on the brakes on and it lit up. I normally park on a fairly flat surface.
#1287 of 1322 starter issues by ru4it May 11, 2009 (1:24 pm)
ok so i have pulled the starter from my '92 prizm but there doesnt seem to be a spot to pull it completly out. there is three things in my way those would be, the passenger CV joint, the suspension brace, and the intake. if someone has an idea on how to completely remove it so that i can replace it plz respond Replies to this message: geoblue (May 12, 2009 9:56 am) dadtofour (May 12, 2009 5:54 pm)
#1288 of 1322 01 Prizm engine by meatypetey May 12, 2009 (6:37 am)
Hi - I'm new to this Forum stuff - WooHoo!! I have a 2001 Prizm w/ 1.8 liter. Is that a toyota engine or a mistubishi engine. I have a knocking that sounds like lifter noise, but can't find any info on replacement lifters??   Also, My wife and have had four prizms. One was good for 250,000 miles +. Two others met with untimely deaths, and my fourth is going strong...so far!!   Thanks for your help!! Replies to this message: geoblue (May 12, 2009 9:58 am)
#1289 of 1322 Re: starter issues [ru4it] by geoblue May 12, 2009 (9:56 am)
Replying to: ru4it (May 11, 2009 1:24 pm) Chilton says:   '1/Disconnect the negative battery cable, 2/Remove the air cleaner assembly with hose, 3/Disconnect all the wiring from the starter terminals, 4/Remove the starter mounting bolts. Remove the starter.'   For 4A-F, 4A-FE and 7A-FE engines. No mention of CV joints, suspension brace or intake.
#1290 of 1322 Re: 01 Prizm engine [meatypetey] by geoblue May 12, 2009 (9:58 am)
Replying to: meatypetey (May 12, 2009 6:37 am) It is a Corolla engine.If it is 2001 it must be VVT-i type engine, with variable valve timing intelligence.   What is the odometer reading on this Prizm?
#1291 of 1322 Re: Geo Prizm spark plug gaps [jcjimenezl] by volleyballdrew May 12, 2009 (1:34 pm)
Replying to: jcjimenezl (Nov 11, 2006 11:21 pm) WHO EVER HAS the MANUAL for the 1992 GEO Prizm.. I NEED The wiring for the radio.. PLEASE HELP FAST.. volleyballdrew2yahoo.com Replies to this message: wolfdragon (Aug 05, 2009 5:30 pm)
#1292 of 1322 Re: starter issues [ru4it] by dadtofour May 12, 2009 (5:54 pm)
Replying to: ru4it (May 11, 2009 1:24 pm) I have replaced the starter on my 94 prizm (twice) Try pulling the starter out from on top instead of dropping it down.
#1293 of 1322 starter removal by glenpointe May 12, 2009 (6:38 pm)
you can get it out from the top. I had done it few times.
#1294 of 1322 engine swap. by softsayocean May 28, 2009 (9:43 pm)
hey im new to this but i have a 96 base prizm w/1.6L manual. and i was curious if anyone knew if the 1.8L engine could be swapped out without any fabrication. plus my clucth is about to go so i figured i would do it all in one full swoop if it worked.

Messages Page 130 of 133 1 ... 127 128 129 130 131 132 133 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Sedans Chevrolet (Geo) Prizm Chevrolet (Geo) Prizm