Ask the Car People.SM


Chevrolet (Geo) Prizm

1443 messages,  Last post on Mar 01, 2013 at 9:56 PM

You are in the Chevrolet (Geo) Prizm Forum.

What is this discussion about? Chevrolet Prizm, Geo Prizm, Sedan

Messages Page 123 of 145

#1214 of 1443 1995 1.6L Prizm 5 sd manual with No acceleration by glenpointe

Aug 23, 2008 (7:27 am)

I have a 1995 Geo Prizm. The car runs great and idles very smooth. But I have one problem and could not figure it out. Sometimes, after shifting from 1st to 2nd gear, and stepping on the gas. The car does not accelerate. It's coasting for few seconds then engine kicks in then the car accelerates. The engine does not rev up during this happens, and it is not struggled or anything. It seems it happens only after from 1st to 2 nd gear. I almost get hit from the car behind when this happens. Any one have the same problem???
Thank you very much!!!

#1215 of 1443 Re: '97 GEO prism, idle problem [newyorkred] by glenpointe

Aug 23, 2008 (7:33 am)

Replying to: newyorkred (Aug 19, 2008 9:46 am)
How does your car idle? did you check the idle air control valve? when your foot off the gas pedal, the throttle valve is closed, but idle air control valve allows a small amount of air to pass thru to keep the engine running. hope this help.

#1216 of 1443 5sp manual - No acceleration after shifting from 1 to 2 gear. by glenpointe

Aug 23, 2008 (8:19 am)

I have a 1995 Geo Prizm. The car runs great and idles very smooth. But I have one problem and could not figure it out. Sometimes, after shifting from 1st to 2nd gear, and stepping on the gas. The car does not accelerate. It's coasting for few seconds then engine kicks in then the car accelerates. The engine does not rev up during this happens, and it is not struggled or anything. It seems it happens only after from 1st to 2 nd gear. I almost get hit from the car behind when this happens. Any one have the same problem???
Thank you very much!!!

#1217 of 1443 Re: Changing Exhaust Manifold. Is it a DYI job? [seasideheights] by glenpointe

Aug 23, 2008 (1:03 pm)

Replying to: seasideheights (Aug 22, 2005 9:47 am)
yes, you can have it done withing 30 minutes. I have mine repalced last week and it took 20 minutes. When you torque the manifold (5 bolts) torque wrench and set at 25 ftlbs. The 2 bolts near the O2 sensor, set at 32ftlbs.

#1218 of 1443 Re: 5sp manual - No acceleration after shifting from 1 to 2 gear. [glenpointe] by geoblue

Aug 23, 2008 (2:17 pm)

Replying to: glenpointe (Aug 23, 2008 8:19 am)
Have you ever had the spark plugs changed? Might be because of old spark plugs, plugged fuel filter, incorrect ignition timing, problem within the emissions control system components etc. Have you ever had the transmission fluid changed on your car?

#1219 of 1443 geo prizm 1991 engine block coolant drain by bereket

Sep 07, 2008 (11:53 am)

someone asked this before but I didn't get the answer - where is the coolant drain plug located on the engine block? The picture looks like it's under the manifold shield but I found one on the other side of the oil filter and it's really hard to get to, and I don't know if it's the one. I'm changing the head gasket and the manual says to drain the block too but maybe it's not necessary. Toyota forums say the plug is on the back of the engine...this is a Toyota engine, right?

#1220 of 1443 Re: 5sp manual - No acceleration after shifting from 1 to 2 gear. [glenpointe] by wisewoman777

Sep 09, 2008 (10:26 pm)

Replying to: glenpointe (Aug 23, 2008 8:19 am)
I have a 1992 Geo Prizm and had problems the last few days with what feels like some vibration and kind of jerking (like maybe not getting gas properly) when shifting between 1st to 2nd gear, and when I read your post, I realized that I have had a mild version of what you described about the lag in pick up for a pretty long time; I had just gotten somewhat used to it and now there is a more noticeable problem with it. I'm curious if you have had any answers from others that can give me a clue how to proceed. One mechanic tells me to just keep driving it, it won't hurt anything. This is my only livlihood and I am between jobs and really need to know what is wrong. Any help so far is appreciated.
Thank you very much!!!

#1221 of 1443 Re: geo prizm 1991 engine block coolant drain [bereket] by glenpointe

Sep 10, 2008 (7:24 am)

Replying to: bereket (Sep 07, 2008 11:53 am)
the coolant drain plug is located below the exhaust manifold near oil pan.

#1222 of 1443 Re: geo prizm 1991 engine block coolant drain [bereket] by glenpointe

Sep 10, 2008 (3:52 pm)

Replying to: bereket (Sep 07, 2008 11:53 am)
the drain plug should be under the exhaust manifold.

#1223 of 1443 Re: geo prizm 1991 engine block coolant drain [glenpointe] by glenpointe

Sep 10, 2008 (3:53 pm)

Replying to: glenpointe (Sep 10, 2008 7:24 am)
your problem sounds like the fuel filter clogging up.

Messages Page 123 of 145

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement