Sign In Join 



Mazda Protege Maintenance and Repair

3600 messages,  Last post on Nov 28, 2009 at 3:21 PM

You are in the Mazda Protege Forum. Your Hosts are pat & karens

What is this discussion about? Mazda Protege, Sedan


Messages Page 349 of 361
1
...
346
347
348
349
350
351
352
...
361
Prev
Next
Last
Go To Msg #
Search This Discussion

#3477 of 3600
mazda protege 97 by giacomod
Apr 03, 2009 (7:56 pm)
Reply
well ; i did test the car for few hours this evening,the car is now more smooth and runs better,especially when on the highway,when i stop completely and in gear once in a while it still hesitate as i idle,is almost like it wants to turn off,but it never does and never did so far,is not as much as when i take off,and that happened few times this evening after riding the car for couple of hours ,
dilemma still there but i am closing in,i am determined to learn more as i go until it is resolve.
#3478 of 3600
Re: mazda protege 97 [giacomod] by 11b33t
Apr 12, 2009 (8:06 am)
Reply

Replying to: giacomod (Apr 03, 2009 7:56 pm)

Any progress on this? I was re-reading your posts and did not see anywhere that the MAF housing had been checked-out..
#3479 of 3600
Re: mazda protege 97 [11b33t] by giacomod
Apr 17, 2009 (4:00 pm)
Reply

Replying to: 11b33t (Apr 12, 2009 8:06 am)

after i had all the inspections done my car first time The engine died ,i took back to the meccanic and they replace the battery the egr valve light come on again,i since then replace the egr valve check all the hose and maf aitr filter atc everything seems fine,after i replace the egr valve the car run great,but after few hours i start up again and the car as the symptoms again,actually it gasp ,trottle when take off or stop in gear, same symptoma as before much less do!the meccanic could not find anything else,but i let the engine run a little and listen where the noise is coming from when i give gas,and that schriekin sound is comin from the alternator.
is possible that the alternator is causing the gasping,and drain my battery before?and mabye it was nothing wrong with the egr r valve in the first place. I will have the alternator tested altough the car never as a problem when i ride on highways.
#3480 of 3600
97 mazda protege by giacomod
Apr 18, 2009 (3:01 pm)
Reply
I want to post some updates,i took the car to autozone,and they tested the alternator ansd check engine light,alternator is good cilinder 3 minsfire,and maf code,check test it ,and the maf it seem works ok,now i have a question for anyone that can help me on this;when i replace the egr valve,i cleaned the holes, from the engine part,i did notice something unusual that i did not talk about earlier ,previously threads,the question is ;
when you take out the egr valve,in the engine there are two holes top and botton,i remember cleaning the top hole,but the botton hole is close and it seems to me that is from the manufacter like that,now i do not know that if it is suppose be that way,top hole is clean and get trough,bottom hole is closed like it is metal,is this normal?
after the egr valve as been replaced the code went away ,but another code come back like i explained before,the problem still there it as a poor idle when stop and when take off it almost seems like it is running out of breath.
i appreciated any of your imput/suggestions. thanks for the help
#3481 of 3600
2002 Mazda Protege ES: Gas smells coming from air vents by benoit6
Apr 30, 2009 (12:49 pm)
Reply
I have a 2002 Mazda Protege ES with 107,000 miles on it, and I have been smelling either gas or exhaust smell coming from my air vents. I smell it when the fan is on and when I'm idling. For the most part, I don't smell it while I'm driving. Even sometimes when I get into the car after it has been parked I smell a gas fumes. I don't see any oil or gas leaks and I don't see any leaks around the fuel injectors. Anyone have any suggestions on what it maybe. I'm taking it to shop to get it diagnosed.
#3482 of 3600
Re: 2002 Mazda Protege ES: Gas smells coming from air vents [benoit6] by autonomous
Apr 30, 2009 (2:08 pm)
Reply

Replying to: benoit6 (Apr 30, 2009 12:49 pm)

Have you checked your exhaust piping leading up to the muffler? If there is a crack or rusting I would think gas may be escaping. The reason you don't smell it when you are moving is because fresh air is being pumped into the compartment to diffuse the smell. It's good that you are taking it into the shop.
#3483 of 3600
Re: 2002 Mazda Protege ES: Gas smells coming from air vents [benoit6] by benoit6
May 01, 2009 (3:11 pm)
Reply

Replying to: benoit6 (Apr 30, 2009 12:49 pm)

Well I took it to the shop, and they said that they didn't see or find any gas leaks nor did they see any holes in the exhaust. They did however admit that when they detached my fuel line to clean the fuel injectors ( a service that was performed awhile ago) they said some of the fuel probably sprayed up near the window where the car vents pull air from. He then stated he sprayed some refresher or cleaner in the A/C to get rid of the smell. I will see if this works.
#3484 of 3600
2001 rear disc brakes by chump2
May 04, 2009 (8:07 am)
Reply
i am going to attempt changeing the rear pads on my 2001 protogeg ES that has rear disc brakes , i see that the emergencey brake is attached to the rear brakes can anybody tell me if there is anything special i need to be concerned about ?
thanks
#3485 of 3600
Re: 2001 rear disc brakes [chump2] by henz
May 04, 2009 (9:07 am)
Reply

Replying to: chump2 (May 04, 2009 8:07 am)

Not really....just un do the cable from the clip....you'll see it....other than that,..just do basic things like supporting caliper w/ wire to prevent strain on hoses...Also, you can't use C clamps to push the piston back....you have to remove cap bolt on back of caliper to access the gear to back off the piston...it requires an allen wrench..not sure what size. Reassemble in reverse order. Pull on the e-brake lever..it will feel very loose first..but will reset itself ( at least in my case ). Hope this helps. Jim
#3486 of 3600
Re: 2001 rear disc brakes [henz] by chump2
May 04, 2009 (9:32 am)
Reply

Replying to: henz (May 04, 2009 9:07 am)

thanks alot , some one had mentioned not to push the piston in with the c-clamp
so this will help .thanks again . this was my first post but i look at the site quit often just to see what problems people have more so to see the respnses

Messages Page 349 of 361
1
...
346
347
348
349
350
351
352
...
361
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement