Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans Mazda Protege Mazda Protege Maintenance and Repair
3584 messages, Last post on Nov 10, 2009 at 9:50 AM
You are in the Mazda Protege Forum. Your Hosts are pat & karens
|
Replying to: spetz (Jan 11, 2009 9:43 am) I recall the problem was with improper sealing around the heater blower, and the repair was fairly involved. |
|
|
Replying to: bdkay (Jan 04, 2009 6:50 pm) I took your advice and did a band aid fix by filling the tank and putting fuel injector cleaner in. The car, once warmed up, ran fine but engine light still on. But no acceleration problems. Took it to the same mechanic and they could not figure it out. The code on the computer gave a random misfire at 0 mph (engine light went off while attempting to accelerate). He said that in order to figure it out without going in and tearing everything apart, they would need to see the engine cold and advised dropping it off and leaving it sit overnight at the shop to be reviewed in the morning. He said they got nothing telling them it was an o2 sensor or lean fuel mixture. But couldnt be certain unless they ran it cold and tried to duplicate the problem. they cleared the codes, engine light off, car ran fine for a week. i allow my car to fully warm up before going anywhere, especially with the cold nights and mornings we have had here in NJ. A week goes by and car starts acting up again...but not nearly as bad. one time since, the car was in idle warming up and i felt it shake periodically, very gently but noticably, for a few seconds and then stop. i will get an occasional hang in acceleration, but by gently working the gas, the car seems to overcome it and resumes normal acceleration. and it occurs less than half the time i drive. however, its very interesting to note that i seem to have the problem more often and worse when its wet or very moist out. for example last saturday it snowed very lightly and my car was out in it for 3 hours since i reached my destination that evening. started fine, but a few miles up the road it started hanging on acceleration again. i got home and didnt drive again that night. next day car worked fine. and for the past few days, again, a few minor periodic hangs in acceleration. however the engine has not been violently shaking when slowing down and going back to idle like it did last time. and the engine light has not come back on. as far as bad gas is concerned, i dont know what you mean. nor would i know the difference. i usually get gas at the lukoil up the street. however for about 3 years strait at my old residence, i would always stop and get wawa gas as it was the cheapest around and on my way home from work. im not sure if my fuel economy is struggling. its hard to tell since my commute to work and back is less than 4 miles round trip. and i havent been driving the car that much in fear of having a problem and being far from home. im actually still on the same tank of gas that the injector cleaner was mixed into.
|
|
|
|
|
Replying to: NJStylee (Jan 13, 2009 11:42 am) I wonder if condensation is affecting your spark plugs as the car warms up. the engine has not been violently shaking when slowing down and going back to idle like it did last time. and the engine light has not come back on. My 2002Protege 5 had a serious shaking problem when the EGR valve failed. The EGR issue is a common problem of Proteges, according to my mechanic. |
|
I baught a 2001 Mazda Protege last april. I love this car. It's great. I have run into some problems with it tho. My oil pressure continously blinks and I've recently had to stop driving it. My car idles fine. But if i try to drive it anytime i get over 2500 Rpm it's starting knocking and clanging. I don't know much about this car it's the frist mazda i've owned. My grandfather is an old fashion mechanic. He can work on any chevy or ford you throw at him. But when it comes to my car he is clueless. I told him about my low oil pressure and he said that it sounded like my oil pump was weak. I've looked everywhere for and oil pump for my car. Nobody has one. Most people say they've never heard of it and then others say they have. I'm very confused. Does my car have an oil pump? If not how do i fix it? The nearest mazda dealership is in missouri. I can't afford to have it towed. What could cause this problem? Where can i find the parts to get it fixed?
|
|
|
|
|
Replying to: mgmazda (Jan 16, 2009 12:33 am) Once that is known, then one can work on possible solutions. You're just guessing here. You may end up doing lots of work for nothing. Here, read up on this, I think you'll find it helpful! Diagnosing Low Oil Pressure--Symptoms and Causes
|
|
|
|
|
Replying to: Mr_Shiftright (Jan 16, 2009 3:32 pm)
|
|
|
|
|
Replying to: autonomous (Jan 20, 2009 2:48 pm) |
|
|
Replying to: tdc1 (Oct 27, 2005 6:45 pm) Your instructions (2765)on horn repair for a 92 Mazda were right on. Tried it today and used styrafoam instead of regular foam and it seems to work fine now. Problem was at low temps the horn blew continuously. We will see how the styrafoam works out over time. Don
|
|
|
|
|
Replying to: dfang (Jan 28, 2009 11:37 am) 
|
|
|
Hi everyone: I am thinking about buying a used 2000 Mazda Protege LX with 112K miles on it. How much do repair costs on this model run in general? I have heard that Mazdas are expensive to fix compared to other cars. Is this true for the Protege? Thanks.
|
|
You are here:
Forums
Sedans Mazda Protege Mazda Protege Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2003 Mazda Protege
Browse by Board
Browse by Topic
Today's Chats
