Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans Mazda Protege Mazda Protege Maintenance and Repair
3581 messages, Last post on Nov 07, 2009 at 7:18 PM
You are in the Mazda Protege Forum. Your Hosts are pat & karens
|
|
|---|---|
|
Replying to: koganagensu (Sep 27, 2008 10:59 am) I would start by checking the battery and then the alternator. You are likely not on the original battery but might be using the original alternator. If so, the alternator becomes the more likely suspect. It might be wise to find a garage you trust and have them check out the car for you. You may find that there are other problem areas (example: spark plugs) and the garage may suggest a schedule for their replacement/repair. |
|
|
|
Help please, I need step by step instructions in removing the center console. I'm needing to reach the air condition fan switch, in order to fix it. The wiring behind the switch has loosened and will work, then stop and then work again. I want to check that because after messing (turning it off and on)with it starts working. Thanks.
|
|
|
|
|
Replying to: gerard8153 (Oct 13, 2008 4:55 pm) |
|
|
I have a 2001 Mazda Protege with about 85,900 miles on it. Sometimes when I make a sharp turn, doesn't matter if it's a left or right turn, my car stalls out. It doesn't sputter, it's more like someone flipped a switch. I'm able to turn my car right back on and it runs normally. What could this be?
|
|
|
Replying to: shelly81 (Oct 20, 2008 8:54 am)
|
|
|
Replying to: maltb (Oct 20, 2008 1:47 pm) About how much will it take to replace a power steering pump? |
|
Yesterday, my car's temp guage was nearing hot or at hot on my commute home. I noticed some antifreeze on the ground, but didn't appear to be leaking from under the engine anywhere. When I popped the hood, the only steam coming out was by the antifreeze coolant box. It was boiling hot and overflowing, dripping out causing steam. I continued on my 40 mile commute home with no issues, just stopping periodically to cool the engine down. I would keep the heat on high to try and drain some of the heat away from the engine, but later no heat would generate, only cold air. No warning lights came on the dash, car seems to run and start fine. What do you think the issue is?
|
|
|
|
|
Replying to: brian374 (Oct 21, 2008 3:49 am) But hopefully you had good luck and no engine damage and so you need to look for the source of your overheating problem. Overheating is caused by a complex range of possible issues and has to be approached methodically, going from the simple to the complicated, and from the most likely to the least likely. The reason you have no heat is that you have low or no coolant in the system. But to the diagnosis: 1. A leak somewhere -- this can be tested doing a 'pressure test' on the cooling system with a pump 2. Stuck thermostat -- remove, test and inspect 3. inoperative electric cooling fans -- test and observe 4. clogged radiator -- this can be "flow-tested" by a radiator shop 5. air in cooling system -- when new coolant was added, system was not properly purged of air with bleed screws or using approved filling methods 6. bad head gasket or cracked cylinder head -- tested with pressure testing pump, and look for coolant on spark plugs or air bubbles in radiator. good luck with it! Hope it's one of the simple ones. Visiting Host
|
|
|
Replying to: Mr_Shiftright (Oct 21, 2008 8:06 am)
|
|
|
|
|
Replying to: brian374 (Oct 21, 2008 10:10 am)
|
|
You are here:
Forums
Sedans Mazda Protege Mazda Protege Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2003 Mazda Protege
Browse by Board
Browse by Topic
Today's Chats
