Sign In Join


Mazda Protege Maintenance and Repair

3503 messages,  Last post on Jun 26, 2009 at 4:41 AM

You are in the Mazda Protege Forum. Your Hosts are pat & karens

What is this discussion about? Mazda Protege, Sedan


Messages Page 340 of 351
1
...
337
338
339
340
341
342
343
...
351
Prev
Next
Last
Go To Msg #
Search This Discussion

#3387 of 3503
2003 Mazda Protege Fuel Filter by jones6826
Sep 20, 2008 (8:17 am)
Reply
Where is the fuel filter located on 2003 Mazda Protege? Thank you so much for your help with this.
#3388 of 3503
Re: 2003 Mazda Protege Fuel Filter [jones6826] by Mr_Shiftright HOST
Sep 20, 2008 (9:14 am)
Reply

Replying to: jones6826 (Sep 20, 2008 8:17 am)

he High Pressure and the Low Pressure Fuel Filters are located in the Fuel Tank on the Fuel Pump Unit, to replace either Fuel Filter you must remove the Fuel Pump from the Fuel Tank.
#3389 of 3503
Re: 2003 Mazda Protege Fuel Filter [Mr_Shiftright] by jones6826
Sep 20, 2008 (9:25 am)
Reply

Replying to: Mr_Shiftright (Sep 20, 2008 9:14 am)

Could the fuel filter be a cause for the motor cutting out when accelerating?
#3390 of 3503
Re: 2003 Mazda Protege Fuel Filter [jones6826] by Mr_Shiftright HOST
Sep 20, 2008 (9:32 am)
Reply

Replying to: jones6826 (Sep 20, 2008 9:25 am)

Yeah but I'd be more inclined to test for a bad fuel pressure regulator, also basic tune up. A fuel filter would have to be pretty clogged up, drastically so.
#3391 of 3503
Re: 2003 Mazda Protege Fuel Filter [Mr_Shiftright] by jones6826
Sep 20, 2008 (9:37 am)
Reply

Replying to: Mr_Shiftright (Sep 20, 2008 9:32 am)

Do you know of any procedures to test/replace the fuel pressure regulator? Where its located?
 
Your help is very much appreciated.
#3392 of 3503
Re: 2003 Mazda Protege Fuel Filter [jones6826] by Mr_Shiftright HOST
Sep 20, 2008 (10:34 am)
Reply

Replying to: jones6826 (Sep 20, 2008 9:37 am)

You need a pressure gauge and proper fittings to break into the fuel injection rail. Then you need to know the specs at cranking and at idle speeds. It's best to have a repair manual to talk you through these procedures, or go to a shop and have the test done.
 
It should read 30 - 36 psi with the fuel pressure regulator connected and 39-45 psi with the fuel pressure regulator disconnected.
 
This test would tell you if the fuel system is substandard in some way. If it reads okay, you go on to other areas such as ignition or sensors.
#3393 of 3503
97 protege problems by koganagensu
Sep 27, 2008 (11:59 am)
Reply
My 97 mazda protege has just started acting up lately. It was fine for a while and now i have to hold the key to start for more than a second to start. After that i will sit in neutral and half the time when i put a little gas on it the engine will knock and either turn back on or just stop. on the occasion where i get it to go around the corner when i get it to about second gear it will cut out and stop. can i get some help please this is my first car and i dont want to lose it.T_T
#3394 of 3503
Re: 97 protege problems [koganagensu] by autonomous
Sep 28, 2008 (3:54 pm)
Reply

Replying to: koganagensu (Sep 27, 2008 11:59 am)

have to hold the key to start for more than a second to start ... half the time when i put a little gas on it the engine will knock and either turn back on or just stop
I would start by checking the battery and then the alternator. You are likely not on the original battery but might be using the original alternator. If so, the alternator becomes the more likely suspect.
 
It might be wise to find a garage you trust and have them check out the car for you. You may find that there are other problem areas (example: spark plugs) and the garage may suggest a schedule for their replacement/repair.
#3395 of 3503
Removing the Center Console by gerard8153
Oct 13, 2008 (5:55 pm)
Reply
Help please, I need step by step instructions in removing the center console. I'm needing to reach the air condition fan switch, in order to fix it. The wiring behind the switch has loosened and will work, then stop and then work again. I want to check that because after messing (turning it off and on)with it starts working. Thanks.
#3396 of 3503
Re: Removing the Center Console [gerard8153] by Mr_Shiftright HOST
Oct 14, 2008 (8:29 am)
Reply

Replying to: gerard8153 (Oct 13, 2008 5:55 pm)

what year is your car?

Messages Page 340 of 351
1
...
337
338
339
340
341
342
343
...
351
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement