Last post on Nov 16, 2013 at 8:34 AM
You are in the Mazda 626
What is this discussion about?
Mazda 626, Sedan
#2067 of 2547 Re: 1997 626 - engine heats up within minutes and shuts off - URGENT HELP! [Mr_Shiftright]
May 26, 2006 (9:37 pm)
Thank you for your help/reply.
Good news...The mechanic said, he has stopped the engine from overheating. He had to change the water hose for this. But he also told me that the compression is low/bad. He wants me to change the engine as soon as possible.
1) Can I drive my car with a low/bad compression? If so, for how long?
2) How will the low/bad compression effect the engine?
3) What must the ideal compression be for a 1997 626 Mazda I4 automatic?
4) Is the compression a serious problem?
He told me that the head and head gasket are OK.
Is there a site where I can read more about all this stuff?
All the info that I have posted so far is from the mechanic.
#2068 of 2547 Re: 1997 626 - engine heats up within minutes and shuts off - URGENT HELP! [veerent]
by MrShift@Edmunds HOST
May 27, 2006 (9:49 am)
Well you need about a minimum of at least 85 lbs of compression in a cylinder to fire it, so sure, you can run with LOW compression but not with TOO LOW compression, or the cylinder or cylinders below about 85 lbs won't fire. You don't want to drive with cylinders misfiring...not only will the car be incredibly slow but you'll ruin your catalytic converter, which will be overwhelmed trying to burn raw gas.
Here's a good explanation:
#2069 of 2547 Any hidden damage to look for after accident?...
May 29, 2006 (11:12 am)
I've got a '99 626 6cyl with 114K miles on it and it's been running pretty good. I recently had an accident though. Another car misjudged and made a left turn from their opposite lane of traffic too soon. I smashed into the side rear of them. I was going about 35mph and both driver and passenger airbags deployed. Most of the impact of my car seems to have been absorbed by the front, passenger side of my car. Aside from that body damage, the car still seems to be running pretty good though. Since the impact was absorbed by the front, I'm not completely sure what, if anything, I should tell the mechanic to double check as far as damage goes. Any advice?
#2070 of 2547 O/D light blinking
May 29, 2006 (8:58 pm)
I just got a '95 626 4 cyl. 92,000 miles, infact driving it on the way home and the O/D light started blinking.. and then I did notice this morning a small spot of transmission fluid under it. I have been reading the forums here and it doenst look good.... does it. Any advice?
#2071 of 2547 Re: Any hidden damage to look for after accident?... [sicsty8]
May 30, 2006 (8:43 pm)
My advice is, if you like your car, pray. Pray very hard. It is likely the damage from the accident will be more than 70% of your car's value, meaning it will be totalled. My son's 2000 626 had a front-end collision at much less than 35 mph recently, and due to the high cost of replacing the airbags and sensors the damage was a few bucks less than the "total it" limit (because they found a couple of used parts, the front bumper and headlamp cover, to bring the cost down), so they repaired the car. But the body had minimal damage--the hood wasn't even damaged, for example, and only one body panel needed to be touched up (and the bumper replaced).
Check the engine compartment very carefully. It appears my son's 626 (I4) developed a vacuum leak of some sort due tot the collision. It got past the shop's inspectors, but we noticed a lot of vibration in the engine after we got the car back, so it is going in for a detailed analysis tomorrow (preliminary analysis is the vacuum leak).
#2072 of 2547 Re: Engine vibration [backy]
May 31, 2006 (1:45 pm)
Update: just talked to the shop, they confirmed the engine is missing but they can't figure out why after 2 days of analysis. They mentioned a TSB for an intake manifold gasket but said the car doesn't have a problem there. So they recommended I take it to a Mazda dealer. (FWIW, the car had a 60k-style servicing 2000 miles ago including new plugs.) Could bad spark plug wires cause this kind of problem? I seem to remember reading about the wires being an issue with the 626.
#2073 of 2547 Thunking gone!
Jun 02, 2006 (4:05 pm)
The "thunks" from the rear of my 2000 626 are gone. It was the rear sway bar bushings. Replacement cost, parts and labor, was $130 (not done at the dealer). I thought this was reasonable especially considering the shop didn't charge me for two days of work spent trying to find the cause of the engine missing slightly (and checking lots of stuff in the engine bay, including cleaning the mass airflow sensor).
#2074 of 2547 1999 Mazda 626 Driver side headlight will not work
Jun 03, 2006 (8:33 am)
Thought maybe somebody saw a similar problem..
The driver side headlight does not work (Passenger side is fine), The brights do not work either.Checked all fuses, they are ok.. Tried 2 new bulbs.. When I press forward on the stem (head light controls) to put on the Brights, the Blue Indicator light does not come on on the dash panel (The brights do come on on the Passenger side headlight though).
With the headlamps on, no brights, I checked the voltages and the 2 side connections to the headlamp bulb are both at 12V. The center Connection (TOP) has no voltage.
I think the issue has something to do with both sides being at 12V, possibly cause the Brights switch is left on?
Any suggestions are appreciated..
#2075 of 2547 Re: Thunking gone! [backy]
Jun 04, 2006 (5:28 am)
Good morning backy,congrats on silencing those pesky
trolls in the trunk. How many miles on your double
ought and how long had those trolls been active?
#2076 of 2547 Re: Thunking gone! [skibry1]
Jun 04, 2006 (9:11 am)
The 626 has about 86k on it now. I bought it in January with 84.2k. The trolls were in the back when I bought it. Since the car had been thoroughly inspected by a mechanic before I bought it, I assumed (stupidly) that the thunks were something loose in the trunk. Fortunately it didn't cost much to fix. The car is perfect now, save for a driver's power lock actuator that is going (still works, I will wait for it to fail) and the engine vibration I mentioned earlier, that started after my son's accident. It has stumped one mechanic, so I will take it to the dealer soon and hopefully they can trace it to the accident (meaning it would be covered under insurance).