Last post on May 10, 2013 at 12:21 PM
You are in the Maintenance & Repair
What is this discussion about?
Fuel System, Electrical, Engine
Jul 08, 2012 (5:36 pm)
dont know if this is right place but i need help. my malibu was down for 5 days..head gaskets replaced by GM dealer. well one hr into the drive hom check engine light came on...n started jumping...stalled out at a red light started n kept trying to stall when it would get lcose to 25 mph. called the dealer he said he wood send someone out to see it..well it was the same KID who supposedly repaired the gaskets. was told its a MAP sensor...drove it back to dealer waited 1 hr replaced the sensor n 1 hr later same thing. by this time dealer was closed. went to where i purches the car n their free diagnostic said MAP sensor...that technician unplugged n plugged it back in. ran good for 20 mins n then same thing died out...n the low eng power kight came on n the car shut it self off n the middle of the street...made it home. called the dealer left a message they cant do anything until monday...im so pissed...what happened to my car.
2008 chevy malibu LS with 78000 miles 3.5L V6 engine...any advice
#1671 of 1688 PO 420 & 430 Cat Codes
Aug 31, 2012 (10:27 am)
2002 Suburban 5.3 L 2WD 1/2 ton 1500 LS
Smog shop said O2 sensors ok and to replace the left and right Cat's which I did but now The codes have reappeared the next day
#1673 of 1688 check engine light blinking - 96 GrandAm
Oct 02, 2012 (4:20 am)
Car drove well this morning until I had to stop for a light. The check engine light comes on once in a while - after gas fillup, but this morning it started to blink and the car started to shake when I applied the brakes - like it wanted to stall. Once I started driving again, the light stopped blinking, but stayed on.
Any ideas? Got me to work, but it's a 20 mile drive back home.
#1674 of 1688 Re: check engine light blinking - 96 GrandAm [jerzeejo]
Oct 02, 2012 (7:39 am)
A loose or leaking gas cap would cause the CEL to come on, and that would fit with the fact it comes on sometimes after filling up. But, I don't think that would cause a driveability problem.
#1675 of 1688 Re: check engine light blinking - 96 GrandAm [jerzeejo]
by Mr_Shiftright HOST
Oct 02, 2012 (8:59 am)
A blinking light is more serious than a steady one. Sounds like some kind of misfire is overheating the catalytic converter. Just keep an eye on that light and you should be okay for 20 miles. Keep your speed down and if there's a way home without hills, do that.
#1676 of 1688 2008 Civic Si sedan Wiring Harness
Nov 28, 2012 (2:53 pm)
Check engine light came on 42k miles, code was bank one sensor 1 heater circuit. Replaced o2 sensor, same code. replaced o2 sensor again same code. mechanic said bad wire was the culprit and replaced a wire and fuse box. same light and same code remained. Took to dealer and they said I needed a new engine wiring harness and the cost was $1050.00 They reset the computer but the same code remains. I am not sure what to do next.
#1677 of 1688 Re: 2008 Civic Si sedan Wiring Harness [selaeration]
by Mr_Shiftright HOST
Nov 29, 2012 (1:05 pm)
Well the first thing would be to get to a good mechanic. Obviously these guys don't know what they're doing.
Are you by any chance in the San Francisco area? I could send you somewhere.
Do you remember the number of the code you read? Just because the code refers to the 02 sensor that doesn't mean the 02 sensor is bad--it only means the 02 sensor is reacting to some irregularity--you could for instance have a catalytic converter problem or a wiring problem.
#1678 of 1688 Re: trouble codes for a 2001 chrysler sebring [0patience]
Jan 17, 2013 (5:33 pm)
I have this p0732 code. just recently got the oil pan and seal replaced due to severel leak. How can I clear this code?
#1679 of 1688 Re: trouble codes for a 2001 chrysler sebring [svarnado]
Jan 17, 2013 (6:03 pm)
Transmission fluid, level or dirty, (if you're lucky).
Something more serious with the transmission if you're not.