Sign In Join 



Jeep Cherokee

2526 messages,  Last post on Nov 03, 2009 at 7:50 AM

You are in the Jeep Cherokee and Jeep Grand Cherokee Forum. Your Hosts are steve_ & tidester

What is this discussion about? Jeep Cherokee, SUV


Messages Page 245 of 253
1
...
242
243
244
245
246
247
248
...
253
Prev
Next
Last
Go To Msg #
Search This Discussion

#2439 of 2526
Re: need seat track...having rocking front seat [paganmomma] by fisherpat
Nov 29, 2008 (6:57 am)
Reply

Replying to: paganmomma (Nov 24, 2008 11:22 am)

try your local auto salvage. If there is a pull and save near you that would be your best bet. I did the track and seat last year and paid 30 dollars total. Good luck.
#2440 of 2526
Re: pcm [loosenut] by mguy
Dec 01, 2008 (10:31 am)
Reply

Replying to: loosenut (Nov 29, 2008 1:52 am)

Well, sounds like you got your hands full. I got a ecm (pcm) from a junk yard and my 96 jeep fired right up. MY 97 grand cherokee Lorado's engine just took a dump. At least i have one running car now. Before the engine (200,000 miles) died , the rear end had been growling also. but that was after i put in new bearings in rear of pumpkin. (pinion bearings??? i guess) Is there any adjustments in there to make noise go away? Noise louder when under load>
#2441 of 2526
Re: pcm [mguy] by loosenut
Dec 01, 2008 (5:51 pm)
Reply

Replying to: mguy (Dec 01, 2008 10:31 am)

i've never really torn down a ring and pinion before,but,i may end up learning how..
--your not giving me a lot of hope for my new aqusition,with yours going "clank"..
did you fry the bottom-crank/rods,or was it electrical?
was yours "all wheel drive"?,are all laredo's?..
-i was thinking about the "all time 4wd,and would trading out the transferr case to a shift in 4wd case-like out of a cherokee- a good idea? would it fit?
my motor sounds good,other than a fresh set of plugs and wires..
were you running that 5w-stuff in it?..they should ban that stuff..someone might use it,and think it lubricates!5w is too thin! 3-in1 oil is 10 weight! DO NOT USE 5W-NOTHING!!..not in anything you want to keep running!!
..guess i'll spend the winter researching some stuff,get in contact with some rock crawler peoples,and make a decesion..here's hoping it makes it through!
#2442 of 2526
interchangable years by paganmomma
Dec 03, 2008 (10:29 am)
Reply
does anyone know if you can interchange an 86 seat track for power seats to the same in an 88?
#2443 of 2526
Re: interchangable years [paganmomma] by mguy
Dec 03, 2008 (2:42 pm)
Reply

Replying to: paganmomma (Dec 03, 2008 10:29 am)

I know this isnt much of an answer, but I bet you can call any junk yard (auto wrecking) and they would know or be able to tell you straight away
#2444 of 2526
Re: interchangable years [mguy] by paganmomma
Dec 04, 2008 (10:20 am)
Reply

Replying to: mguy (Dec 03, 2008 2:42 pm)

Yep your right it didn't help much because it was the junk yards that weren't sure if it did or not. They have an 86 track, but aren't sure it fits the 88 seats. I guess I will have to go done and look at it and compare. Thanks though.
#2445 of 2526
Re: interchangable years [paganmomma] by lildavidjax
Dec 04, 2008 (10:34 am)
Reply

Replying to: paganmomma (Dec 04, 2008 10:20 am)

Did you call the dealer and inquire if the part number was the same? Too simple or what?
#2446 of 2526
Help, diagnose front end problem by onebear
Dec 04, 2008 (9:18 pm)
Reply
I have a very used (180,000 miles) 1994 Cherokee 4.0L. I bought it 3 months ago. A week ago, I noticed a grinding sound coming from the front drivers side when turning right or left. This gradually got louder. Before I was able to get it in the shop, the grinding sound was replaced with a loud snap, then a thump, thump, thump, (also very loud!) that accelerated with speed. I could feel the thumping on the drivers side floor board. I drove it the 12 miles home. I am sure causing even more damage. I have been reading other posts and it seems that it could be many things associated with the axle, hub, etc. Could someone please get me started looking in the right direction. Thanks!
#2447 of 2526
99 grand cherokee ltd by bandit13
Dec 20, 2008 (8:14 am)
Reply
how to remove glovebox and or dashboard. having ventilation prob's an am looking into installing "heater treater" parts.
#2448 of 2526
Re: 99 grand cherokee ltd [bandit13] by loosenut
Dec 20, 2008 (12:15 pm)
Reply

Replying to: bandit13 (Dec 20, 2008 8:14 am)

go to "autozone.com"
set up a account-enter your kind of car,and they have a online manual-with exploded views,this will give you a idea of what comes apart,and where to look for the screws ..
"heater treater?..maybe heater core?..anyway,the online manual is there..maybe that'l help..
merry christmas

Messages Page 245 of 253
1
...
242
243
244
245
246
247
248
...
253
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement