Sign In Join 



Jeep Grand Cherokee

2465 messages,  Last post on Nov 24, 2009 at 6:34 PM

You are in the Jeep Cherokee and Jeep Grand Cherokee Forum. Your Hosts are steve_ & tidester

What is this discussion about? Jeep Grand Cherokee, SUV


Messages Page 242 of 248
1
...
239
240
241
242
243
244
245
...
248
Prev
Next
Last
Go To Msg #
Search This Discussion

#2404 of 2465
2006 Grand Cherokee Headlights by harry0
Dec 03, 2006 (5:46 pm)
Reply
My low beams seem to be bothering oncoming traffic. One out of every 30 to 40 cars flash there high beams at me although I have my low beams on. I have been back to the dealer to have them check the lights out. The dealer says everything is fine but I’m not so sure. The low beams do seem very bright to me and they seem to aim up much higher and brighter than my 2003 Chevy pickup. The low beams also light up the interior of the cars coming from the other direction.
Has anybody else noticed this on there Jeeps?
 
2006 Jeep
http://rides.webshots.com/album/548697188kmhzhY
#2405 of 2465
Re: @ A Possible $4.00/ Gal Would You Still Buy A Jeep? [blankster] by jday2
Dec 08, 2006 (12:53 pm)
Reply

Replying to: blankster (Nov 28, 2006 8:27 am)

I have a 2002 jgc overland. My heat or ac does not work. The blower works fine, the thermostat is ok, as well as the heater core. I believe the problem lies in the vacuum system. The flaps that open to allow the cool or hot air to pass through are not opening. The heat didn't work for 2 months and then worked for 2 days, and now hasn't worked for 8 months. The temperature of the air that blows is accurate with the temperature outside. I have taken the jeep to three different mechanics, and not one of them could figure out the source of the problem. Any suggestions? I'm freezing my ass off.
#2407 of 2465
Re: @ A Possible $4.00/ Gal Would You Still Buy A Jeep? [jday2] by blankster
Dec 11, 2006 (4:57 am)
Reply

Replying to: jday2 (Dec 08, 2006 12:53 pm)

There are known problems with the blender doors failing on WJ Jeeps with the dual zone climate control. See WJJEEPS.COM.
#2408 of 2465
Re: @ A Possible $4.00/ Gal Would You Still Buy A Jeep? [jday2] by hayhow1
Dec 13, 2006 (7:02 am)
Reply

Replying to: jday2 (Dec 08, 2006 12:53 pm)

try tracing down all the small vacuum lines. pay close attention to the ones that run under the battery, make sure they dont have any breaks in them.
#2409 of 2465
Re: Diesel Grand Cherokee starts Production Jan/07 [frostyy] by frostyy
Dec 24, 2006 (4:59 am)
Reply

Replying to: frostyy (Nov 13, 2006 5:51 am)

Update on Diesel Grand Cherokee Production:
 
Production on the 2007 diesel Grand Cherokee has been pushed back until Feb. 22/07....
#2410 of 2465
1994 cut off. by jeepinjoeszj
Dec 25, 2006 (10:53 pm)
Reply
My 1994 5.2 just did this today, I turned it on it idled smooth for about 10-15 secs and cut off. No sputtering no "stalling" just cut straight off, as if I had turned the ignition off. And it will not start back, it turns over just won't start. I haven't had a good chance to look at it yet and am just looking to find the best place to start. I believe it to be an electrical problem, be it a fuse or relay or short. Dunno yet. Any ideas?
#2411 of 2465
Re: 1994 cut off. [jeepinjoeszj] by enegma
Dec 30, 2006 (1:27 am)
Reply

Replying to: jeepinjoeszj (Dec 25, 2006 10:53 pm)

The problem could be the ECM (Engine Control Module)which is located on the right side of the engine near the distributor. It will be sealed in black rubberized epoxy. This is a sealed unit and cannot be repaired.You need to get a code reader to verify what code comes up. That will point you to the problem area. The other cause could be your timing chain or belt since it will no longer start.
 
Cost for replacing timing chain or belt $350.00 approx.
Cost for replacing ECM (new) $650.00 (junkyard) $200.00
 
Since your vehicle is a 1994 and depending your mileage and how frequently you change your oil, I would suspect the timing chain first. ECM rarely fail. I hope this helps.
#2413 of 2465
Re: 1994 cut off. [enegma] by holey24
Feb 06, 2007 (2:02 pm)
Reply

Replying to: enegma (Dec 30, 2006 1:27 am)

I had the EXACT same thing happen to my Jeep (same Jeep as well) and I replaced the ECM..and now I'm getting the same probs all over again..with added extras!! Were you able to solve your problem? If so could you let me know..thanks

Messages Page 242 of 248
1
...
239
240
241
242
243
244
245
...
248
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics
Advertisement