Ask the Car People.SM


Nissan Pathfinder

8189 messages,  Last post on Nov 27, 2012 at 10:22 AM

You are in the Nissan Pathfinder Forum.

What is this discussion about? Nissan Pathfinder, SUV

Messages Page 805 of 820

#8036 of 8189 1995 Nissan Pathfinder SE 4WD by jcash

Mar 30, 2006 (11:05 am)

I bought This 1995 Nissan Pathfinder SE 4x4. I had it sitting for 1 Year . I put new brake pads. I ordered a Master Switch to see if the power windows start working because when i got The Computstar Alarm Installed The guy showed me they worked but they keep blowing a Fuse. Other than that . My Water Pump started leaking Antifreeze and now i paid $600 to get it replaced with a new one and the mechanic start he would have to rearrange the timming belt. I was wondering if anyone knows any information on Superlift suspension for the 1995 Nissan Pathfinder Se 4wd?

#8037 of 8189 Re: Still going.... [duper] by flmidwife2b

Apr 04, 2006 (3:37 pm)

Replying to: duper (Dec 28, 2000 2:58 pm)
Have 1999 Nissan Pathfinder SE so far have replaced transmission, Crank shaft pulley, Idler pulley, Battery, Alternator, Spark plugs, Air filter, Fuel filter. Now this isn't all at once the most recent was I admit I am one that likes to see the orange fuel light come on then drive another 50 miles. Well long story short car wouldn't start put more gas after jump would start had to tow home. Since changed battery then would start but would die after short distance (down block). Start with simple stuff checked fuses changed spark plugs first time in 128,000 changed air filter, fuel filter now code is reading faulty fuel temperature sensor does anyone know where this is located. Also the pathy smells of gas everytime try & start it. Lines checked should I just drop the fuel pump and change it or what route??? Help I learned my lesson!! Also any ecu information would be wonderful. Mama gotta get to work!

#8038 of 8189 New JOb by jcash

Apr 05, 2006 (9:29 am)

I have the 1995 Nissan Pathfinder Se 4wd It was continously overheating and leaking antifreeze. Come to find out its the water Pump i paid $715 to get the water Pump replaced along with the timming belt .. And to take the Crank Shaft Pulley Replaced aswell. All new belts were inserted the mechanic states that i drove the car so much while it was overheating i burnt one of the Cylinders. So its a V5 not V6 can this be true because ever since the water pump was changed its not in correct timming and the car idles funny all day.

#8039 of 8189 Side to Side Motion by frenchfries

Apr 14, 2006 (4:08 pm)

I have a 98 Pathfinder, I cant figure out why sometimes its shakes side to side when Im driving, could it be the shocks? or the suspension itself?

#8040 of 8189 Re: Side to Side Motion [frenchfries] by jcash

Apr 14, 2006 (9:22 pm)

Replying to: frenchfries (Apr 14, 2006 4:08 pm)
You might want to check the motor Mounts . Their Cheap at Autozone. If the Problem continues Shocks

#8041 of 8189 Re: Side to Side Motion [frenchfries] by pathstar1

Apr 15, 2006 (8:06 am)

Replying to: frenchfries (Apr 14, 2006 4:08 pm)
Actually, if you read back in the posts on this forum you will find it's probably the rear suspension bushings. It's a common problem with older Pathfinders. As those posts say, you could replace just the bushings, but the labour would probably make it better to just replace the arms, bushings and all. Unless you want to go to Urethane bushings - then just replace the stock bushings with new Urethane ones.

#8042 of 8189 98 timing belt kit (crank pulley removal) by phalanx

Apr 24, 2006 (5:27 am)

Im planning to replace the timing belt (kit)Idler,belt,2ea seals,2ea hoses,thermostat & water pump. My question is the harmonic balancer. The manual shows a chain strap wrench to hold balancer, I can't find this wrench at any auto shops/stores in my county. What would you recommend other than this?
Thank you for your time.
Chris

#8043 of 8189 Re: 98 timing belt kit (crank pulley removal) [phalanx] by phalanx

Apr 27, 2006 (3:38 am)

Replying to: phalanx (Apr 24, 2006 5:27 am)

#8044 of 8189 i would check for the wrench online by jcash

Apr 27, 2006 (8:49 am)

yea i would go to www.ebay.com
or do a search on google.com because if your doing the work yourself youll be saving about $700 in labor

#8045 of 8189 Re: i would check for the wrench online [jcash] by phalanx

Apr 27, 2006 (10:13 am)

Replying to: jcash (Apr 27, 2006 8:49 am)
I have, not a reply from any of them as of yet,guess I'll have to use a block of wood for a wedge.

Messages Page 805 of 820

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement