Sign In Join



Isuzu Rodeo

2186 messages,  Last post on Jun 15, 2008 at 5:20 PM

You are in the Isuzu Rodeo Forum. Your Hosts are steve_ & tidester

What is this discussion about? Isuzu Rodeo, Honda Passport, SUV


Messages Page 195 of 219
1
...
192
193
194
195
196
197
198
...
219
Prev
Next
Last
Go To Msg #
Search This Discussion

#1939 of 2186
Re: Thump while braking or accelerating [highjumper25] by blainemetfan
Apr 20, 2006 (10:23 pm)
Reply

Replying to: highjumper25 (Apr 03, 2006 6:16 am)

I have a 1997 Honda Passport and there is a thumping under the front passenger side when we slow down and speed up. Usually happens going around 10mph or less. We need to figure out what the hell this is!!!
#1940 of 2186
Re: ABS [seeya1] by buck380
Apr 21, 2006 (2:24 pm)
Reply

Replying to: seeya1 (Mar 11, 2006 3:52 pm)

Check to see if there was a recall for your rodeo. I know the 98 had one re faulty abs sensor that caused the light to go on.
#1941 of 2186
rear brakes by toy03
Apr 21, 2006 (5:54 pm)
Reply
I have a 2003 rodeo . if i drive for about 35 to 40 miles on the highway when i come to a stop then start moving again it feels like the rear brakes are sticking it makes a loud grinding noise. it only happens on long drives around town its fine anyone else have this promblem.
#1942 of 2186
stupid question by tdogg2
Apr 25, 2006 (9:27 pm)
Reply
I just bought a rodeo. I can not open th back hatch. The button unleashes the spare tire and can feel the door is unlocked. The problem is the door can not be opened without the window being opened. That is the problem. I can't get it opened. I have no owner's manual. It is a 96. Any suggestions would be appreciated.
 
Thanks
#1943 of 2186
two switches by eqpassport
Apr 26, 2006 (9:21 am)
Reply

Replying to: fabian (Feb 09, 2006 4:31 pm)

There are two switches that operate when you press the clutch pedal.
 
The first one signals the cruise control that the pedal has been depressed ands subsequently disables cruise control. This switch is normally depressed when in gear or at rest.
 
The second switch is located at the other end of the clutch pedal travel and us located closer to the firewall. This switch does not allow the engine to start unless it is depressed by pushing the clutch pedal all of the way in. I have installed a momentary switch in parallel with the OEM switch so that I may start with the transmission in neutral and the clutch pedal in it's normal position.
 
My point is: It is relatively easy to crawl on the floorboard and look to where the pedal swinds back toward the firewall. You will see a switch mounted to a bracket. Pull the connector and either test the switch or replace it.
#1944 of 2186
Re: Dredded Check Engine Light [dorionone] by Cathe
Apr 29, 2006 (10:54 am)
Reply

Replying to: dorionone (Apr 20, 2006 10:58 am)

to reset the 'check engine light':-
 
remove fuse no. 4 to clear memory
#1945 of 2186
Re: Euro lights [freedom247] by hikick1
Apr 30, 2006 (6:13 pm)
Reply

Replying to: freedom247 (Mar 30, 2006 7:22 am)

they are on ebay search "altezza rodeo"...you will find them....
#1946 of 2186
Re: oxygen sensor or img [boogoo] by hikick1
Apr 30, 2006 (6:24 pm)
Reply

Replying to: boogoo (Feb 16, 2006 7:09 pm)

Is there a "tool" I can purchase to use at home to get trouble codes for my 92 4x4 rodeo? I have the manual with codes. Thanks for any help.
#1947 of 2186
Re: lifters relaced, still ticking... [9204rodeo] by hikick1
Apr 30, 2006 (6:45 pm)
Reply

Replying to: 9204rodeo (Sep 19, 2005 6:01 pm)

has your 92 rodeo ever ran like it was starving for fuel or surging upon high speed accelleration? I have a new fuel system and exhaust. The exhaust shop told me I had a broken off manifold bolt after they were done....could seepage be the problem? thanks
#1948 of 2186
Re: 96 Isuzu Rodeo Tail and Dash Light Problem [ghedra] by sullyair
May 06, 2006 (11:17 pm)
Reply

Replying to: ghedra (Jul 08, 2005 7:09 pm)

I had the same problem on my 1995 Isuzu Rodeo. I found that the headlight relay (under the hood) controlled the tail lights and dash lights as well. Actully, I didn't need to replace the relay, I unplugged it, put it back in and everything worked.
 
Mike

Messages Page 195 of 219
1
...
192
193
194
195
196
197
198
...
219
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics
Advertisement