You are here: Forums SUVs Chevrolet Blazer Chevy Blazer GMC Jimmy Maintenance and Repair

Chevy Blazer GMC Jimmy Maintenance and Repair

3451 messages,  Last post on Dec 05, 2009 at 8:12 PM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Blazer, GMC Jimmy, SUV

Messages Page 346 of 346 1 ... 340 341 342 343 344 345 346 Prev Next Last

Go To Msg # Search This Discussion

#3448 of 3451 1995 gmc jimmy spider injector by jaba7530 Nov 06, 2009 (10:11 am)
I am changing the spider injector on my 1995 gmc jimmy but does anyone know which line goes into which hole in the intake? thanks alot Replies to this message: cpuhach (Nov 07, 2009 8:55 am)
#3449 of 3451 Re: 1995 gmc jimmy spider injector [jaba7530] by cpuhach Nov 07, 2009 (8:55 am)
Replying to: jaba7530 (Nov 06, 2009 10:11 am) doesnt matter which hole , all same, ...least it was when I did mine.
#3450 of 3451 Changing starter motor in 1998 chevy blazer 4.3 V6 by emydee23 Dec 05, 2009 (4:42 pm)
I am trying to remove the stater motor in a 98 Chevy Blazer 4.3L vortec V6 4x4. It isn't a very easy part to get to, and I had major issues getting the bolt closest to the right side out, and am struggling with the second bolt. From what I have read and researched, it only takes the two main bolts to free up the unit for removal (aside from the wires). I also saw an additional page that states it may have a heat shield. Do you know if this vehicle has said heat shield?   On another note, while I am doing the stater, am also considering installing new wires at the same time. What wires on the distributor go to which spark plugs? And where does the 7th wire go? The passengers side has 4, drivers side has 3 on the cap. Replies to this message: blazergirl96 (Dec 05, 2009 8:12 pm)
#3451 of 3451 Re: Changing starter motor in 1998 chevy blazer 4.3 V6 [emydee23] by blazergirl96 Dec 05, 2009 (8:12 pm)
Replying to: emydee23 (Dec 05, 2009 4:42 pm) Yes there is a heat shield...access to the heat shield is through a hole cut in the inside of the wheel well, covered with a rubber flap. Wires I don't know about...replace them one at a time as not to mix them up.

Messages Page 346 of 346 1 ... 340 341 342 343 344 345 346 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Chevrolet Blazer Chevy Blazer GMC Jimmy Maintenance and Repair