You are here:
Forums
SUVs
Mitsubishi Montero
Mitsubishi Montero

2809 messages, Last post on Aug 03, 2009 at 1:46 PM
You are in the Mitsubishi Montero Forum. Your Hosts are steve_ & tidester
|
|
|---|---|
|
I have a Mitsubishi Montero Sport and recently replaced my stereo equipment (head unit, subs box, amps) due to theft & the box for my subs is about 2 inches higher than the level of my tonneau cover when it is extended. I don't want the outline of the box to be seen, so need to raise the level of the tonneau cover height itself. I'm wondering if this kind of thing has already been done by someone in the forum and, if so, they might have some ideas on how to approach such a project. getting a lower box is not an option because the JL Audio 12W7 needs the cubic inches in the box as it currently is. Any suggentions/advice that anyone has about a custom fabrication job to raise the height of the tonneau cover in the trunk would be much appreciated. Thanks. |
|
|
|
|
Replying to: sbeach (Jan 25, 2006 11:13 am) The problem appears to be in the heater or AC hose. If I have it bled the sound goes a way for a while. Not I just live with it. BTW I put a put an ARB front bumper with a 9000lb winch on after a little deer incident. Someday i post a link to some photos of my Montero. |
|
|
|
|
Replying to: rbt0005 (Feb 29, 2008 4:25 pm) |
|
|
Replying to: sailing216 (Apr 19, 2007 6:59 am) |
|
|
Replying to: npanneri (Oct 18, 2005 2:07 pm) |
|
|
|
2001 3.0 V6 running rough, hesitates at about 2300 RPM, and stalls at about 600 rpm. The OBDII codes that the MAF sensor is faulty. I replaced it with a remanufactured one. No change in performance, so I replaced it two more times; still no change in performance. Unplugged, the engine runs fairly good and does not stall at idle (won't pass inspection though). Plugging in the MAF sensor at idle speed causes the engine to stall. Any ideas? How could I test the wiring harness and the MAF sensor?
|
|
|
|
|
Replying to: KCWBurleson (Dec 29, 2008 8:44 am) |
|
|
|
|
I have a 1985 montero 4 wheel, 2.6. My transmission is shot, slipping out of 2nd and 4th. Bleeding fluid from the main shaft. I need to replace or rebuid it. Question Can I use the 1985 mits truck transmission for the Montero? It's about 300 bucks, where the montero tranny is expensive. It seems to me that the tranny could be the same. any ideas |
|
|
|
Hello, do not have manual, but does anyone know if the middle set of seats roll forward once the back of the seats are down? do they dislodge from the floor to roll up? Thanks
|
|
You are here:
Forums
SUVs
Mitsubishi Montero
Mitsubishi Montero
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2006 Mitsubishi Montero



Browse by Board
Browse by Topic
Today's Chats