You are here: Forums SUVs GMC Yukon GMC Yukon / Yukon Denali

GMC Yukon / Yukon Denali

3260 messages,  Last post on Apr 28, 2009 at 7:02 AM

You are in the GMC Yukon Forum. Your Hosts are steve_ & tidester

What is this discussion about? GMC Yukon Denali, GMC Yukon, SUV

Messages Page 325 of 327 1 ... 321 322 323 324 325 326 327 Prev Next Last

Go To Msg # Search This Discussion

#3235 of 3260 factory subwoofer option '04 DXL' by denalidad Nov 30, 2008 (1:16 pm)
Has anyone heard of a factory subwoofer that would be located in rr drivers side compartment in back of vehicle where the plastic has a spot that looks to be for a subwoofer? I am told that this was an option from the factory that came with an amp attached right to the subwoofer and wired into existing bose system as option. Replies to this message: obyone (Nov 30, 2008 3:51 pm) fixitrod (Apr 24, 2009 1:22 pm)
#3236 of 3260 Re: factory subwoofer option '04 DXL' [denalidad] by obyone Nov 30, 2008 (3:51 pm)
Replying to: denalidad (Nov 30, 2008 1:16 pm) The factory manual indicates what you state to be correct.
#3237 of 3260 Driver door ajar and speedometer problem by nrogers Dec 24, 2008 (6:38 am)
My 2003 denali is starting to have some issues that are driving me nuts. First of all the speedometer needle is stuck facing down(as if I drove 140mph and it got stuck down there). Of course I never drove that fast. Anyone know how to fix this or how much it is going to cost? Also, I am getting a driver door ajar message and the lights come on and off while I am driving as well as the door locking and unlocking. I notice this started when we had a lot of rain but it went away originally. Now it is not going away. Any idea how to fix this without getting a loan to pay for it? Replies to this message: djtwisted (Mar 13, 2009 7:34 am)
#3238 of 3260 PLEASE HELP ! 2005 YUKON 43000 miles by paulkc Dec 25, 2008 (10:43 am)
My Yukon's check engine light is on and it feels like its going to die at stoplights. I had a buddy check the codes and 3 popped up: too lean, multiple misfires and low voltage. BUT the problem is inconsisent! It will sometimes run okay and theres no problems when idling in Park except check engine light is still on. Weather doesn't seem to be a concern, as it did it in 1 degree weather and also 38 degree weather, (crazy Kansas weather!)   I have a new battery in it, (less than 1 month), and dealership advised alternator was fine when they put it in.   Described problem to dealership and they think it might be an intake manifold gasket shrinking up in the cold...BUT...it was fineuntil a few days ago when it had sat in the 1 degree cold all night. It ran for 30 minutes around town then when I strarted it up again, it started this problem. The plugs are iridium and should be good til 100k miles.   Any ideas are greatly appreciated, as I dont have much $$$ to pay somone for hours of poking around. Thanks! Paul, Overland Park KS Replies to this message: obyone (Dec 25, 2008 12:17 pm) paulkc (Jan 03, 2009 2:05 pm)
#3239 of 3260 Re: PLEASE HELP ! 2005 YUKON 43000 miles [paulkc] by obyone Dec 25, 2008 (12:17 pm)
Replying to: paulkc (Dec 25, 2008 10:43 am) Check engine light is usually associated with emissions. In your situation it seems like it could be the MAF sensor as it leans or enriches the amount of fuel to air mixture based on air intake temperature. I would find it unusual as the MAF isn't known to fail on the Yukon, but there are instances where I've seen them in need of replacement. Replies to this message: paulkc (Jan 03, 2009 2:05 pm)
#3240 of 3260 Re: PLEASE HELP ! 2005 YUKON 43000 miles [obyone] by paulkc Jan 03, 2009 (2:05 pm)
Replying to: obyone (Dec 25, 2008 12:17 pm) HA! At first the dealership said it was fuel injectors which had fouled up. THEN after making it 100 yards out of the dealership, it acted up again, so after another 24 hours, they advised it was the catalytic converter, which was causing the back pressure problem and apparently fouling up everything else. Hopefully they will test drive it this time, cuz I will have had this rental car for almost 10 days! Thanks for the info. Paul
#3241 of 3260 2004 GMC Denali by Dookiefan Jan 20, 2009 (5:40 am)
I have recently had both my front heated seats stop working on me. Neither of the lights come on, I am thinking its a relay, but not sure which one? I was looking last night and there are multiple clusters, Can anyone help?  Also I have an obnoxious rattle/squeak in my passenger side dash? sounds like it is deep into the dash, any thoughts?  thanks for your help!~
#3242 of 3260 Re:torsion bar adjustment on my 00 yukon 4 wheel by fongerelli Feb 04, 2009 (9:24 am)
Replying to: obyone (Feb 28, 2006 8:40 pm) I need to raise the front a little how do I adjust the torsion bar? Replies to this message: rsht (Feb 07, 2009 10:23 am)
#3243 of 3260 Re:torsion bar adjustment on my 00 yukon 4 wheel [fongerelli] by rsht Feb 07, 2009 (10:23 am)
Replying to: fongerelli (Feb 04, 2009 9:24 am) I am not absolutely sure about your particular year model, however, the torsion bar adjustment is done by turning the torsion bar adjustment bolt (follow each torsion bar from the lower control arm toward the mid section of the vehicle, you should find the adjustment bolt at about the section below/behind the driver seat for the left side and opposite for right) . It will be much easier to turn each bolt if you jack up the front end (you can do this one side at a time) by the frame to take the weight off of the front suspension. Find a reference point on each side and take initial measurements before making the adjustment; measure each side of the SUV again after adjustment to make sure both sides were raised to the same height. You may need to have the alignment checked after adjusting the torsion bars...
#3244 of 3260 torsion bar adjustment on a 2000 Yukon by fongerelli Feb 07, 2009 (2:50 pm)
Thanks for all the advice and it worked! It raised the front end about an inch which gave me more room for my 35 x 12.50 x 16.5" mud tires! I'm still hitting the windshield tank when I turn hard right though. I shaved as much as possible without any leakage. I might have to move it foward or up or re-position it elsewhere? Any thoughts on this anyone?

Messages Page 325 of 327 1 ... 321 322 323 324 325 326 327 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs GMC Yukon GMC Yukon / Yukon Denali