Last post on Apr 17, 2012 at 3:54 PM
You are in the GMC Yukon
What is this discussion about?
GMC Yukon Denali, GMC Yukon, SUV
#2822 of 3279 Re: 02 Yukon SLT with windshield noise [dcdchau]
Mar 16, 2005 (8:49 am)
Body - Windshield Area Wind Noise
Bulletin No.: 04-08-48-003
Date: June 14, 2004
Windrush Around Windshield (Install New Windshield Reveal Moldings)
2002-2004 Cadillac Escalade
1999-2004 Chevrolet Silverado
2000-2004 Chevrolet Suburban, Tahoe
2002-2004 Chevrolet Avalanche
1999-2004 GMC Sierra
2000-2004 GMC Yukon, Yukon XL
with Hood Air Deflector
Built Prior to the Build Dates shown.
Plant Build Date
Pontiac Assembly 12/17/03
Ft. Wayne 12/15/03
Some customers may comment on noise coming from the windshield and door area.
This condition may be caused by the installation of a hood air deflector. The deflector may change the path of the air across the vehicle, causing the left side and right side windshield reveal molding to make noise.
Replace the left and right side windshield reveal molding. Refer to the Windshield Side Reveal Molding Replacement procedure in SI.
Parts are currently available from GMSPO.
For vehicles repaired under warranty, use the table.
#2823 of 3279 Re: 02 Yukon SLT with windshield noise [obyone]
Mar 16, 2005 (2:59 pm)
obyone, many thanks... Will ask the dealer to check this TSB out. They found some loose part inside the truck, under the dash area and tightened it. I don't think this will rectify my wind shield noise. The TSB you mentioned will. Especially mime has the hood guard installed. Thanks again obyone and thank you forums.
#2824 of 3279 Re: quiet weekend [steve_]
Mar 16, 2005 (3:36 pm)
I would but I'm not a new owner...
Mar 16, 2005 (7:09 pm)
Looking for comments on aftermarket exhaust
systems for the 6.0. Considering a Flowmaster
or Spintech but am concerned with resonance
Mar 17, 2005 (10:02 am)
Has anyone replaced their stock 265/70R17s with 285/70R17s? BFG All-Terrain T/A is the only tire I've seen in this size. They'll fit on the stock 8" rims, but I'm curious how they fit otherwise. I have a 2004 Yukon XL 4x4 with 3.73 gears.
The Firestones seem to be lasting pretty well. Typical, since I can't wait to get rid of them.
#2828 of 3279 Cleaning CD player?
Mar 21, 2005 (6:57 am)
I have an '02 Denali (6-CD changer) which is starting to have intermittent problems playing CDs. It's like there's some dust/lint on the lens or something, and occasionally it skips though most of the time it plays perfectly. Anyone have any experience servicing/cleaning the CD player?
Thanks in advance for any responses.
#2829 of 3279 Re: Exhaust Systems [mmacfarlane]
Mar 25, 2005 (8:37 am)
I went with a pretty free flowing Magnaflo muffler, but did need to add resonators to maintain a fairly quite highway ride. Nice little added sound on acceleration with minimal noise on the highway. Check out post #2663 for the parts.
The big trick for me was to add two pipes (one each side). Slide the spare tire back toward the bumper by remounting (put the hoist through one of the spokes and use a 12" bolt with washers to fasten the other end to the frame. There is a hole in the frame that allows you to do this).
Works easy on a XL - gives you enough room to run a second pipe between the rear axle and the tire.
My buddy did it on a non-XL which was a little more tricky, we got a slightly smaller tire, then did the same thing. He had 20's on his ride, so the slightly smaller tire was not a huge deal, but in case of a flat, you don't want to run on it very long or at very high speeds due to the AWD.
My big concern on the second pipe was I did not want to run it too close to the brake lines. I used the insulation on a couple parts just to insure no problems. I also added it above the resonators and muffler to make sure I did not get any noise. Probably not necessary, but if you buy a sheet of the insulation, you might as well use it.
#2830 of 3279 Re: [cornellpinoy]
Mar 26, 2005 (9:59 pm)
We put hid conversion into 02 Denali and are interested in having low beams stay on all the time, even when high beam is switched on. Is there a way to accomplish this?
#2831 of 3279 2003 Yukon XL Roof rack exchange
Mar 28, 2005 (5:18 pm)
I have a 2003 Yukon XL and was wondering if a roof rack from a similar year Suburban Z71 would fit in the same mounting holes. Does anyone know?