- #423 of 511
-
Re: 1997 Blazer Wiper question [imatoolman]
by angieandrohan
-
May 03, 2007 (10:52 pm)
-
|
|
Replying to: imatoolman (Nov 14, 2000 2:16 am)
Your wiper motor maybe fine or burnt out by now but putting a new one only going to burn out again GM's Blazer and Jimmy have that problem the mechanical parts under the cowl where the wiper arms screwed to is seized you have to remove the cowl that black plastic piece below the windshield, removed the wiper arm first then remove the two end piece then the middle piece then loose the nuts at the base where the wiper arms was and that center nut on the motor also remove the wiper motor carefully remove the mechanism spray some W-D40 on each joint then oil each joint, then work it with your hand till it free up, if the wiper motor is still good every thing will be fine but some times when the mechanical parts seized up like that it puts pressure on the motor and burns it out, if you are going to put a new motor make sure you do what I told you and you'll be OK,GM have a good plan but ashamed to let the Japanese refined it, water keep wetting the mechanism under the cowl and that’s why after a while it seized up, my wife paid over six hundred dollars to fix our truck because I wasn't here and it stops before I get home I had to buy a new motor again and do all that I told you and now the wipers are OK, and it only cost me $87 dollars for the new motor at AutoZone, I hope you can do this yourself the dealer makes more money repairing these trucks than what they made selling them, and if you have rear wiper take that out and do the same thing too don't Waite for it to stop.
Hope I was of help.
|
- #424 of 511
-
SECURETY LIGHT (98 GMC JIMMY)
by angieandrohan
-
May 03, 2007 (11:13 pm)
-
|
|
My SECURETY LIGHT comes on sometimes when I am driving, which let me know the pass lock system not working properly some time the truck start up and shuts off immediately no matter how much times you starts it, it just shuts off like its out of gas then after about ten minutes it starts and every thing is fine, when I check the manual I've learned that if this happens you are to Waite ten minutes then start and it will start but I can't take this anymore does any one have any remedy for this situation, I don't want to go to the dealer, most time that’s just waste of money. Thanks
|
- #425 of 511
-
Re: SECURETY LIGHT (98 GMC JIMMY) [angieandrohan]
by repairdog
-
May 04, 2007 (2:19 am)
-
|
|
Replying to: angieandrohan (May 03, 2007 11:13 pm)
Need a body code scanner to look at and they are the $200 plus range but the dealer is the best for this as they have seen them. Usually its in the column either the hall effect sensor on the tumbler or the wiring and connector (called the ignition switch - don't ask why) so a pain to fix either way. Good luck because at some point it may fail completely and not restart - have to fix it soon. Was the dash pulled for a heater core recently cause that may be the reason as the connector was not firmly reseated.
|
- #426 of 511
-
Re: SECURETY LIGHT (98 GMC JIMMY) [repairdog]
by angieandrohan
-
May 04, 2007 (3:05 pm)
-
|
|
Replying to: repairdog (May 04, 2007 2:19 am)
Thanks I do that yes there seems to be an AC leak under the dash and the technician tried to find it, so I think that’s what causes the problem I'll just take it to the dealer as you said thanks again.
|
- #427 of 511
-
Re: Not so solid [richman98]
by nevrbyajimmy
-
May 04, 2007 (5:31 pm)
-
|
|
Replying to: richman98 (Jul 13, 2000 6:18 am)
Sounds just like my 1998 Jimmy 4dr. How well does your rear wiper work ? mine hasn't worked for years , Power mirrors are nice but in true GMC fashion , they quit working a long time ago !! The fi rst and only time I tried to recline my seats the levers broke off , now i just use a screw driver . what kind of crap is GM trying to sell ??
|
- #428 of 511
-
Re: Not so solid [nevrbyajimmy]
by angieandrohan
-
May 04, 2007 (6:47 pm)
-
|
|
Replying to: nevrbyajimmy (May 04, 2007 5:31 pm)
now it works with a loud screechy noise, my power mirrors don't works any more, my seats don't recline anymore cause the levers are all broken, there's a loud cracking sound at the front end when I turn the steering fully to left or right, GM really sucks. 
|
- #429 of 511
-
can it be done
by fbpatriot14
-
May 17, 2007 (8:28 am)
-
|
|
Can a 1995 chevy blazer be chipped or does it have to be tuned with a tuner?
|
- #430 of 511
-
Re: can it be done [fbpatriot14]
by repairdog
-
May 18, 2007 (3:04 am)
-
|
|
Replying to: fbpatriot14 (May 17, 2007 8:28 am)
Good question and not sure but the Jet catalog should tell you - if its ODB II then Jet has the add on module. Those juts fool the temp so run richer thus more HP but would have to say mpg drop. The turners are like $300 plus and can override the top speed limiter (why cause at 93 the things will be shaking), reset tire size/odometer, and shift points. For a stock vehicle spend your money on quality ignition parts and filters!
|
- #431 of 511
-
Re: SECURETY LIGHT (98 GMC JIMMY) [angieandrohan]
by philipminer
-
May 18, 2007 (12:29 pm)
-
|
|
Replying to: angieandrohan (May 03, 2007 11:13 pm)
My 2000 GMC Jimmy does the same thing (intermittently does not start). I believe it is the motor senor that is located on the front of the crank where the harmonic balancer is. I am going to get it fixed at a dealer. When I do, I will report the result and cost.
|
- #432 of 511
-
Re: 1996 Jimmy - smoking AC unit... [greazyjungle]
by angieandrohan
-
May 20, 2007 (8:59 pm)
-
|
|
Replying to: greazyjungle (Jun 01, 2006 1:51 pm)
Most likely the AC clutch is jam so when you turn on the AC it jam the AC pulley which cause the serpentine belt to burn trying to turn the AC pulley it happen to me before, if you let the AC stays on it will cause the belt blaze (fire) I would advice you to change the AC compressor  .
|
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs 
