You are here:
Forums
SUVs
Chevrolet Blazer
Chevy Blazer/GMC Jimmy

511 messages, Last post on Nov 29, 2009 at 11:19 AM
You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester
|
|
|---|---|
|
Replying to: patel1 (Dec 04, 2005 8:19 pm) Hello Blazer owners I am a new Blazer owner just bought my first 4 months ago. Got a 2000 Chevy Blazer ( my dream vehicle).I have always wanted one. Well I am having troubles and no one seems to know what could be causing it. I have no heat. and with living in PA with temps lately in the 20's everyday it gets pretty chilly without a heater. It is odd had heat till Thanksgiving day, went out and started the truck and just didn't seem to warm up. I thought might be due to that it was only 11 degrees out, the next week had heat back but it was warmer too. Now this past week i barely have any you can feel it there, but just no where near as warm as should be or was. Now I have had talked to about 10 different mechanics including my dad who has worked on Chevy's for 40 yrs. They all seem to be lost. Seems to be blowing both cold and luke warm air. We have changed the thermostat. The fluids are full the radiator is full. The hises that go into the heater core are warm to touch, but i was told you should not be able to sit there and hold them and you can. Please Help!!!
|
|
|
Replying to: chevyladyinpa1 (Dec 10, 2005 6:07 pm) |
|
While driving, I can hear my turn signal flasher clicking, but I have not turned on my signal. The signal indicator isn't lighting up, but the flasher is clicking. It is purely random, but does it continually. The turn signals work fine when I do turn them on. I replaced the flasher, but same issue. I'm guessing a short somewhere, but before I spend hours trying to track it down, wondered if anyone has any ideas of an easy fix.
|
|
|
|
|
This is the most anoying thing in the world! I'm driving and it sounds like my turn signals are on. Does anyone know how I can fix this problem before I drive this thing off a cliff. Thanks |
|
|
Replying to: marlonfloreslc (Dec 14, 2005 9:34 am)
|
|
|
I have a 96 blazer. A fuse keeps blowing and when it does all of the gages go dead and the altinator stops charging the battery. I've replaced the fuse and it will work for a while but then it will blow again. I think it is a loose/pinched wire however I have no idea which wires to check. |
|
|
Replying to: makpiette (Dec 15, 2005 6:03 am) Chevy Blazer/GMC Jimmy: Problems & Solutions Steve, Host |
|
|
Replying to: rodneys10 (Oct 13, 2005 6:21 pm)
|
|
|
Replying to: christy73 (Dec 05, 2005 2:04 pm) 1: Record your Radio security code or set it to "0000" 2: Check the switches in the Dash to make sure they are not defective. 3: Disconnect the battery for 3 minutes and try to engage the 4WD. CAUTION--SEE STEP 1 If at this point you still have no 4WD the it is most likely the Transfer Case Controller (Located in the Dash or Right Kick Pad)or the Transfer Case Encoder Motor (located in the Transfer Case). |
|
|
Replying to: chevyladyinpa1 (Dec 10, 2005 5:48 pm)
|
|
You are here:
Forums
SUVs
Chevrolet Blazer
Chevy Blazer/GMC Jimmy
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2005 Chevrolet Blazer
2001 GMC Jimmy



Browse by Board
Browse by Topic
Today's Chats