- #309 of 511
-
problem
by patel1
-
Dec 04, 2005 (8:17 pm)
-
|
|
I have a 96 blazer 4wd that heat but not enough what would be the problem
|
- #310 of 511
-
problem
by patel1
-
Dec 04, 2005 (8:19 pm)
-
|
|
Oh and i think it is the heat core but not sure and the blower is still blowing and heat comes out but not enough
|
- #311 of 511
-
power seats please help !!!!
by christy73
-
Dec 05, 2005 (1:58 pm)
-
|
|
i have a 1995 chevy s10 blazer and my power seats stopped working. does anyone know where i begin to correct the problem.
|
- #312 of 511
-
1995 chevy s10 blazer isnt engaging
by christy73
-
Dec 05, 2005 (2:04 pm)
-
|
|
my 4x4 isnt engaging. i have a 1995 S10 chevy blazer and my 4x4 is push button with 4hi 4 low neither is working when i push them they just make a clicking noise then the light remains on. im assuming its an electrical problem by reading other forums and talking to my father hows a mechanic but he overhauls motors and doesnt deal with this thing. so i was hoping someone could help me out. if it is the electronic engagement what should i be expecting to pay to get this problem fixed.
|
- #313 of 511
-
adjusting lights
by christy73
-
Dec 05, 2005 (2:05 pm)
-
|
|
how do i adjust my headlights they seem to be pointing downwards hi and low beams
|
- #314 of 511
-
Re: power seats please help !!!! [christy73]
by mrakes
-
Dec 05, 2005 (6:52 pm)
-
|
|
Replying to: christy73 (Dec 05, 2005 1:58 pm)
I have a 1997 blazer 4x4 that had the same issue. My power door locks as well as my power seat quit working. I replaced the fuse w/ a relay for testing. I tried door locks, seats and all worked fine. When I sat in the driver seat, the relay tripped. I began checking the wiring under the seat and saw nothing apparent. Once I removed the driver's seat I notice the power lumbar support wires that ran between the seat frame and the seat had became raw. I removed the switch, taped up the wiring and re-ran the wires thru the hole in the seat frame (which I believe is where it should have been from the factory) and have not had any problems in over 6 months.
|
- #315 of 511
-
Re: adjusting lights [christy73]
by 4hourmechanic
-
Dec 05, 2005 (7:35 pm)
-
|
|
Replying to: christy73 (Dec 05, 2005 2:05 pm)
If it is like my 93 blazer, there should be a screw to the right or left, and right above the headlight (it might be a torx) and you turn them to adjust the direction. Park like 20 feet away from a wall, so that you can see the beam, and adjust accordingly.
|
- #316 of 511
-
Re: 1995 chevy s10 blazer isnt engaging [christy73]
by patel1
-
Dec 05, 2005 (8:29 pm)
-
|
|
Replying to: christy73 (Dec 05, 2005 2:04 pm)
you should press eather button when you are in park, then when it is blinking still, shift to reverse or drive and it should work
|
- #317 of 511
-
1995 chevy s10 blazer
by christy73
-
Dec 05, 2005 (10:15 pm)
-
|
|
how do i replace the bulb in the back of the truck i cant figure how to get the cover off to fond out what sorta bulb i need
|
- #318 of 511
-
Re: I think I might can help... [my_blazer2000]
by fiverailer
-
Dec 07, 2005 (4:56 pm)
-
|
|
Replying to: my_blazer2000 (Apr 30, 2005 10:11 pm)
My "SERVICE ENGINE LIGHT" is constantly on, i didn't think it was because of the real problem that i have. The real problem now is that i live in Nebraska and we have had consecutive nights of weather below 0, not easy on my blazer which has a heating issue. Its not a issue with the truck heating up, engine tempurature comes up just fine, takes a little while before the fan produces any hot air in the interior. it is now 6 years old pretty much and just had i believe it's first proper radiator flush and the thermostat as well. Without the fan on it seems to get hot, specially around the vents.....i turn the fan up and slowly the air becomes luke warm, if that even. I can turn the fan off let it ride a lil and turn it back on and gets warm again. I wish i knew why it was doing this, I am afraid that it is the heater core and am hoping that it is just a sensor or electrode messing it up. If you can help that would be great. Peace
|