Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs Ford Explorer Ford Explorer Maintenance and Repair
6241 messages, Last post on Nov 24, 2009 at 9:06 AM
You are in the Ford Explorer Forum. Your Hosts are steve_ & tidester
|
Replying to: tulsahog (Jan 29, 2009 11:24 am) When selecting LO or HI, there is no clicking sound behind the glove box. Also, all 4x4 fuses are good. Disconnected neg term of battery for short time, but no effect when reconnected. Does this sound like the 4x4 module? Any way I can check or need to take to dealer? |
|
|
|
|
Replying to: electricdesign (Jan 09, 2009 1:35 pm) the poster you are responding to, has made only 1 post. they are a troll or a 'plant' who make a negative comment and does not post again. 
|
|
|
|
|
My 96 Ford Explorer is making a loud tone (usually one pure pitch, occasionally two pitches) after about 5-15 minutes of driving. The tone has an abrupt onset and offset and lasts anywhere from 3 seconds to a minute. It seems independent of engine speed. It tends to happen more often when the outside temperature is below freezing, and when the temperature gauge is about 1/3 up in the normal range. The tone is very loud and seems to come from the front of the car under the hood. Does anyone know what this might be? Thanks. |
|
| i am trying to replace the belt on my 94 explorer. how do i release the tension arm to swing it around to but the belt on it? | |
|
Replying to: bioman (Apr 21, 2008 6:03 pm)  aol.com
|
|
|
|
|
Hello All: I have a 1998 Ford Explorer XLT with AWD and 5.0L V8. My problem is a Terrible Vacumm leak. There's an open port where a hose used to be hooked up. It's right underneath the top intake cover, towards the firewall on the right side.(its next to the master cylinder.) I plugged it for now with a 3/8 vacuum plug and its back to normal idle. but I don’t want to damage anything by " jimmy-rigging." like that. I don’t see any hose's loose anywhere, and I really cant figure out how to read the diagram under the hood very well to try and trace in back to where its being fed from. Any suggestions? any and all help would be greatly appreciated. Thank you for your time
|
|
|
Have a 2006 Explorer. Had oil change today and Ford mechanic said the left front axle seal was starting to leak. Can anyone give me an idea fo what it will cost to replace and repair this seal? Have an extended service warranty but wanted to check the price first. Have a $200 deductible on the warranty. Problem is nothing serious at the moment just some very small drips (less than a teaspoon a day). Thanks |
|
|
Replying to: ibusem (Mar 22, 2009 7:58 am) Bioman |
|
|
Hi, I have a '94 Explorer sport with automatic four wheel drive. It engaged in 4wd earlier this week, but when i tried to take it back out it would not do anything, the lights on the dash and by the buttons are no longer lit up, but its still in 4wd. when I push the button, it does nothing, not even a sound from the actuator in the back. Nor do the lights light back up... I checked the fuses and they are all fine, I did both tests on the actuator its self and there is nothing wrong with it. I even tried replacing the push button on the dash with another used button, but still nothing. Does anyone have any ideas? Has this happened to anyone before? |
|
You are here:
Forums
SUVs Ford Explorer Ford Explorer Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Ford Explorer
2010 Mercury Mountaineer
Browse by Board
Browse by Topic
Today's Chats
