Sign In Join 



Ford Explorer Maintenance and Repair

6242 messages,  Last post on Dec 08, 2009 at 11:36 AM

You are in the Ford Explorer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Explorer, Mercury Mountaineer


Messages Page 615 of 625
1
...
612
613
614
615
616
617
618
...
625
Prev
Next
Last
Go To Msg #
Search This Discussion

#6133 of 6242
Re: 1998 Ford Explorer - no start = fuel problem? [fatback] by ksteven
Oct 21, 2008 (10:31 pm)
Reply

Replying to: fatback (Jan 24, 2007 3:08 pm)

hey lovelylu42 did u get ur problem fix i am having the same problem i have a 99 explorer an having the same problem did the same thing with the fuel pump also my injectors not opening.
#6134 of 6242
Re: 2002 Explorer Fan doesn't blow very well except on high [edvanhal] by fordsrus2
Oct 22, 2008 (4:19 pm)
Reply

Replying to: edvanhal (Oct 21, 2008 7:24 pm)

The fan switch itself may be your problem, as it controls the level of the fan speed. Regardless, it seems that it would have to be one of the two, fan speed swt or fan motor. However, I would think it's more likely the fan swt itself. I had an Explorer that had similar symptons and the fan swt itself turned out to be the problem. Again this is the actual swt that you are turning to set your fan speed. In reference to the noise that you hear at the highest setting, there may be something that's getting into your fan blades causing this, as I know leaves are sometime bad about working their way into the fan blades. Hope this reply helps, as it may at least give you a couple of things to consider....
#6135 of 6242
I think it's the clutch pack by jezima
Oct 27, 2008 (7:48 am)
Reply
I have an 05 explorer XLT with 35K miles and on Saturday I noticed that when I go to turn right or left at a low speed, there will be this grinding sound and shimmy in my rear end..What is it? And will this be an ongoing problem once it's fixed..should I just trade it in
#6136 of 6242
2004 Ford Explorer-Whistling noise by jeddyboy
Nov 06, 2008 (6:27 am)
Reply
I have a 2004 Ford Explorer with 23,000 miles. Anytime I get it over 55mph, there is a whistling noise while I am pressing the accelerator. Take my foot off the accelerator and it stops. We can't seem to figure out where it is coming from. Can anyone help!?
#6137 of 6242
Re: re: transmission fluid [swschrad] by flagat
Nov 11, 2008 (6:54 pm)
Reply

Replying to: swschrad (Apr 25, 2000 2:35 am)

Will transmission fluid being sucked into the manifold cause the engine to surge and create a knocking sound in the intake manifold?
Also, I have a '94 explorer and it's been surging. I was told by the good people at Auto Zone that it was my EGR valve, which I've replaced and still have the problem.
#6139 of 6242
03 explorer power door lock problems by 1sttimeford
Nov 15, 2008 (1:42 pm)
Reply
I am having trouble with the driver's side door lock control that is mounted on the door. The rocker control will not lock or unlock the doors unless the engine is running. Key FOB and door key pad work fine anytime. Also, the puddle lamp on the driver's side no longer works (bulb is fine). The key warning chime continually sounds when the vehicle ignition is off, all doors are closed, and the key is still in the ignition slot. Any ideas? Are all these related?
#6140 of 6242
'02-XLT - ABS light On and Cruise Control does not work by dublinca
Dec 02, 2008 (12:18 pm)
Reply
I recently changed all 4 brakes and resurfaced rotors at the Ford dealer in Livermore CA. After I pick the Explorer, ABS light comes on after driving for a few minutes and now the Cruise does not work also. I took it back the next business day to the Livermore dealer and told it will cost me $180.00 for some electrical switch that goes on the master cylinder. computer code: C1440 -- Pressure difference - Transducer Circuit failure.
 
I never had any problem in my car related to ABS or Cruise Control and dealer says it not their fault... its a coincidence... I can't seem to buy that. Does anybody know which part is this and if I can replace it myself...Ford Part #. and or image??
#6141 of 6242
1996 Ford Explorer by Happy1125
Dec 03, 2008 (10:03 am)
Reply
My truck is a standard I stalled out and could not start. If i bypass wires on the solenoid i can get it to start. Someone said it could be the neutral safety switch. Is there anyway i can get a diagram or find someway to locate where the problem might be. i thank you very much for any help possible
#6142 of 6242
windshield wiper by ajmtbm
Dec 21, 2008 (1:05 pm)
Reply
2002 explorer.
 
when it was a couple years old i noticed that when cold the driver side windshield wiper didn't seem to work well.
took it to the dealer they replaced the wiper blade. helped a bit.
 
now i notice if i pull in on the base of the washer arm, the whole units moves - i think this is why it doesnt wipe well (passenger side doesnt do this - it is tight).
 
does anyone know if there is an easy way to tighten this up... maybe its as easy as tightening a bolt somewhere?
 
thanks

Messages Page 615 of 625
1
...
612
613
614
615
616
617
618
...
625
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement