Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs Ford Explorer Ford Explorer Maintenance and Repair
6126 messages, Last post on Oct 08, 2008 at 8:52 AM
You are in the Ford Explorer Forum. Your Hosts are steve_ & tidester
|
|
|---|---|
|
Replying to: cathil (Apr 20, 2008 8:07 am) |
|
I have a 2003 Explorer (87,000miles). there are times that it will run extremely rough, it is almost like is will stall out. It does this while driving and while idling. It is the worst when I am sitting at a stop sign or light. The check engine soon light comes on and off. some days it is on and others it is off. Does anyone have any ideas as to what could be causing this. I have taken it and had it put on the computer. Usually it says system to lean, I have replaced 2 O2 sensors, spark plugs and wires, crank shaft sensor.
|
|
|
Replying to: cathil (Apr 20, 2008 8:07 am) |
|
|
I just replaced the front rotors & pads on my daughter's 2002 Explorer XLT. Was looking for a way to adjust the parking brake. The 02 Explorer is quite different from my 99 XLT. Checked the www could find no reference for the parking brake adjustment on an 02 XLT. My 99 was a simple adjustment of the rear parking brake shoes. Did not find an adjustment slot on the 02. Thought I'd give this site a shot before going to purchase Chiltons. Thanks, Bioman |
|
|
On a 4.6L V8, I started to change the coolant and discovered there is no radiator cap. The only place to add coolant is the plastic recovery bottle and it is pressurized. Can a DIY'er do this or does it require special tools and procedures? Fortunately, I had not drained the coolant. Did I overlook something? The manual only says to add coolant at the bottle.
|
|
|
|
|
Replying to: tulsahog (Apr 23, 2008 7:46 am)
|
|
|
Replying to: egyptgerry (Apr 23, 2008 9:36 am) Called the dealer service dept and they said they remove the top radiator hose and pump out the coolant and replace it using their equipment. He could not tell me how to do it without this special equipment. For 50 yrs I have been able to simply change coolant in cars, but maybe this is a casualty of newer vehicle technology. Has anyone actually changed the coolant in their garage on this or a similar Explorer?
|
|
|
Replying to: tulsahog (Apr 23, 2008 10:18 am) The pressure bottle is safer, less likely to burn you. Personally, I don't like them either, and don't trust them, but amazingly, they do seem to work and hold up well. Just one more thing to explode IMO, but as I said, they are quite common now.
|
|
|
Replying to: nvbanker (Apr 23, 2008 4:03 pm) It looks like I could drain the coolant and refill thru the recovery bottle. There is about a 1" dia hose from the bottom of the bottle to the bottom of the radiator and a small overflow hose to the top of the radiator. The small hose goes into the radiator just above the top radiator hose. So, I should be able to refill thru the bottle and the overflow hose should be a vent for trapped air as the radiator fills. Looks like if the Exp is on level ground, I could fill up to the cold mark in the bottle, then run the engine and recheck after cooling down. Please advise your thoughts on this method. Looks like this would be easier than removing the top radiator hose. The local dealer wants $118 to flush and refill. I realize this method does not flush the system, but I have had a bad experience with flushing in the past. It caused a heater core leak on an earlier vehicle.
|
|
|
Replying to: tulsahog (Apr 24, 2008 6:50 am)
|
|
You are here:
Forums
SUVs Ford Explorer Ford Explorer Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2009 Ford Explorer
2009 Mercury Mountaineer
Browse by Board
Browse by Topic
Today's Chats
