Sign In Join

Ford Explorer Maintenance and Repair

6115 messages,  Last post on Aug 31, 2008 at 5:22 PM

You are in the Ford Explorer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Explorer, Mercury Mountaineer


Messages Page 606 of 613
1
...
603
604
605
606
607
608
609
...
613
Prev
Next
Last
Go To Msg #
Search This Discussion

#6044 of 6115
ford explorer 1997 no first gear by egyptgerry
Apr 09, 2008 (1:00 am)
Reply
Hi there ,got a 97 ford explorer and it suddenly has no bottom gear,i can drive it in 2 and drive but if i start in drive nothing happens just a faint noise from the box,any ideas Guys
#6045 of 6115
Re: 2004 Ford Explorer XLT instrument panel lights flickering [gator_fan] by nvbanker
Apr 09, 2008 (7:26 am)
Reply

Replying to: gator_fan (Apr 08, 2008 7:12 pm)

It's not a systemic problem, it's a problem isolated to your panel lights. The fix, however, isn't cheap nor easy. The panel will probably need replacement. The only other possibility is a faulty reostat on the dimmer for the panel lights. That would be easier. This is a very very rare problem, but I'm sure that's not comforting, sadly.
#6046 of 6115
Re: Don't buy an Explorer [ginamillar2000] by nvbanker
Apr 09, 2008 (7:28 am)
Reply

Replying to: ginamillar2000 (Nov 11, 2007 10:19 am)

Be sure an check the Honda Pilot Maintenance & Repair board, and take note of the people accessing their state's Lemon Laws regarding their PIlots......you may need to do the same.
#6047 of 6115
service engine soon light(2002 ford explorer) by cathil
Apr 20, 2008 (8:07 am)
Reply
Hi I have a 2002 explorer, the service engine soon light came on and I hear a rattling noise maybe coming from under the hood, also its seems to be running a little jerky.
thanks
#6048 of 6115
Re: service engine soon light(2002 ford explorer) [cathil] by egyptgerry
Apr 21, 2008 (12:34 am)
Reply

Replying to: cathil (Apr 20, 2008 8:07 am)

It sounds like you need to get it into a service shop,Bye the way do people ever check the oil and water levels these days?The rattle you have ?well the Explorer has a timing chain but they dont give trouble on the newer ones,Have you looked under the hood to see if you can spot the rattle,Running Jerky well that can be a h/t lead braking down i know on the early Explorer 97/98 changing the spark plugs was like Night Mare on Elm Street.I honestly think that they where fitted before the Engine was into the car,
#6049 of 6115
rough Running 2003 Explorer by jmkuchen
Apr 21, 2008 (8:15 am)
Reply
I have a 2003 Explorer (87,000miles). there are times that it will run extremely rough, it is almost like is will stall out. It does this while driving and while idling. It is the worst when I am sitting at a stop sign or light. The check engine soon light comes on and off. some days it is on and others it is off. Does anyone have any ideas as to what could be causing this. I have taken it and had it put on the computer. Usually it says system to lean, I have replaced 2 O2 sensors, spark plugs and wires, crank shaft sensor.
#6050 of 6115
Re: service engine soon light(2002 ford explorer) [cathil] by nvbanker
Apr 21, 2008 (11:00 am)
Reply

Replying to: cathil (Apr 20, 2008 8:07 am)

The light is telling you that your engine is in trouble - the engine is running jerky, telling you that it is in imminent danger if FAILING!! Get that poor car to the dealer NOW, and have it checked out, before you do some irreparable damage to the car.
#6051 of 6115
Adjustment for Parking Brake 2002 Explorer XLT by bioman
Apr 21, 2008 (7:03 pm)
Reply
I just replaced the front rotors & pads on my daughter's 2002 Explorer XLT. Was looking for a way to adjust the parking brake. The 02 Explorer is quite different from my 99 XLT. Checked the www could find no reference for the parking brake adjustment on an 02 XLT. My 99 was a simple adjustment of the rear parking brake shoes. Did not find an adjustment slot on the 02. Thought I'd give this site a shot before going to purchase Chiltons.
 
Thanks,
 
Bioman
#6052 of 6115
How to change coolant on '02 Explorer by tulsahog
Apr 23, 2008 (7:46 am)
Reply
On a 4.6L V8, I started to change the coolant and discovered there is no radiator cap. The only place to add coolant is the plastic recovery bottle and it is pressurized.
 
Can a DIY'er do this or does it require special tools and procedures? Fortunately, I had not drained the coolant. Did I overlook something? The manual only says to add coolant at the bottle.
#6053 of 6115
Re: How to change coolant on '02 Explorer [tulsahog] by egyptgerry
Apr 23, 2008 (9:36 am)
Reply

Replying to: tulsahog (Apr 23, 2008 7:46 am)

Ok,first never try to open the recovery bottle when the engine is hot,To check and add coolant this has to be done when the engine is cold,Firsy check the level in the bottle it should be about half way up,There is a line on the bottle and if the coolant is low then just top it up via the recovery bottle,If it is half full and you need to add Antifreeze fluid then you need to let out come water from the Recovery bottle hose,Hope this helps.GERRY

Messages Page 606 of 613
1
...
603
604
605
606
607
608
609
...
613
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement