You are here:
Forums
Pickups
Chevrolet Silverado & GMC Sierra
GMC Sierra: Problems & Solutions ![]()

1492 messages, Last post on Oct 12, 2006 at 5:32 AM
You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram
|
Replying to: shiftless (May 22, 2006 5:22 pm)
|
|
|
Replying to: obyone (May 26, 2006 3:56 am) |
|
|
The vehicle is 2003 gmc sierra...I have this squeaking noise that seems to be coming from behind the gauges. Took front and bottom part of the dash apart and I still am unable to fix this....any ideas? |
|
|
Replying to: titojermaine (May 23, 2006 5:21 pm) |
|
|
2003 GMC 1500HD, 6.0 L; I am having an intermitent problem with the speedometer. It will often display much higher than actual speed. When stopped the gauge will read 20 or 30 mph. It comes and goes. I've been told that everything is electronic now. It sounds like it must be the gauge. Any thoughts? Do you have to replace just the speedometer or the whole gauge cluster? |
|
|
|
|
Has anyone found a tool that helps in changing the distributor cap, or any other easy way to change the cap for that matter? I have a 1998 Sierra 3500 Dually 4wd. Last time I changed the distributor cap and rotor it was an 8 - 10 hour thing, because the cap is under the intake manifold so it is very difficult to tighten one of the cap's screws. |
|
|
Replying to: noobie1 (Nov 30, 2005 9:32 am) I finally found something to post on here. The "piston slap" issue is really a load of crap. Dealers say it does it on start up and goes away, but I have noticed while driving the valves rattle like you have bad gas. The knocking you hear is more than likely the roller lifters with no oil at start up. The excuse piston slap is used is how the design of the engine and where the lifters are placed in the engine. They are held in place with in a grouping of 4 in a container that is bolted to the block. Due to the design the opening is large enough to amplify any engine noise near the pistons and the heads are bolted directly on top of the lifter gallies making it difficult to make this repair. I pulled the valve cover and ran the motor with little or no oil coming thru the pushrods on the lifters. I also have found out that the oil pumps can fail with no warning and have ran as low as 6psi at idle which the dealer says is normal. I am in the process of replacing the oil pump and lifters and hopefully will remedy my situation. It has not burned oil, like I have read on sites where 2-4 quarts of oil between oil changes is normal by dealer or GM customer service standards but it is not normal, I have had several GM's in the past and 1 quart or less in 3-5k was normal. I really love my truck and yes GM has got problems but they better get their stuff together and take care of the customer instead of being in denial or they will not have customers. |
|
I have a 2002 GMC Denali PU 6.0L W/Quad Steering. Between 30-40MPH I experience a vibration noice (sounds like a heat shield vibrating maybe) When the vibration begins and I hold my speed steady, the vibration will not go away. I do not lose power or feel any change in vehicle handling. It is just anoying. Does anybody have any clues
|
|
|
Replying to: jf3761 (Jun 20, 2006 5:49 pm) and your truck is a 02 I am betting on a loose heat sheild on your cat(s). Those cheap spot welds just break/rust off thus causing the vibration(s). Try driving a few wood wedges between the cat and muffler and see if it cures your problem.
|
|
|
Guys: My father has an 2000' model GMC Sierra with a 5.3L/V8 Vortec Engine. Nice truck with somewhere in the neighborhood of 35,000miles. Lately his blower motor is very loud when using the heater/ac/vent. I told him I would write on here and see if any one had any ideas of why this is. Just the blower motor going bad? or can something else cause this? Thanks guys, kimble989 |
|
You are here:
Forums
Pickups
Chevrolet Silverado & GMC Sierra
GMC Sierra: Problems & Solutions ![]()
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 GMC Sierra 1500
2004 GMC Sierra 2500
2006 GMC Sierra 3500



Browse by Board
Browse by Topic