Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Vans & Minivans Chrysler Town & Country/Dodge Grand Caravan Chrysler Minivan Transmission Problems
1833 messages, Last post on Nov 10, 2009 at 3:54 AM
You are in the Chrysler Town & Country/Dodge Grand Caravan Forum. Your Host is Karens
|
|
|---|---|
|
Replying to: roro121 (Jan 15, 2009 10:26 am)
|
|
|
|
|
Replying to: roro121 (Jan 15, 2009 10:26 am)
|
|
|
Replying to: leadfoot69 (Jan 15, 2009 1:00 pm)
|
|
|
|
|
Replying to: roro121 (Jan 15, 2009 4:25 pm) |
|
|
|
|
I bought this van the other day. It has 158k on it. The test drive at the dealeship was done when the van was cold. It worked perfect. I drove around one mile ( it was snowing). I bought the van and trailered it home. Today when the license plates arrived I let the van run a long time outside ( 8 degrees outside). The first time driving the van at normal engine temperature - the transmission will not shift out of low. I have reverse and low. No check engine lights are on. The fluid is a nice bright red and filled to the full line. The dealership - Buhler in Hazet, New Jersey will not assist in any repairs or refund. Any adivse would be helpful as I have to sell one of my work trucks or cars to fix my wifes new/used mini van.
|
|
|
|
|
Replying to: sonofadocker (Jan 16, 2009 2:17 pm) and did you bring engine up to redline and stilled didn't shift?The reason i ask this is because these trannies will shift even if you have it in low on gear selector when approaching redline engine will make tranny shift that is if it has the 4 speed electronic tranny.and that could be an indication of a bad selector sensor or kick down cable stuck down.
|
|
I have a 1997 T&C 3.3 engine. The reverse will not work, and I am getting a trouble code says -Incorrect gear ratio2 and another code about the trans control unit. I Replaced the selonid pack, unpluged the trans computer, cleared codes and still no difference. I also changed fluid, with the atf4 fluid and new filter, I did not notice any fresh metal in the pan. It will start to drive a bit then just loses the drive, if I reset it it will start to drive again, but then lose out. But No reverse at all. Any help would be much appreciated.
|
|
|
|
|
Replying to: cridez (Jan 16, 2009 4:58 pm)
|
|
|
Replying to: leadfoot69 (Jan 16, 2009 5:07 pm) I thought about trying to get another trans computer at the local salvage yard, seems like it is stuck in limp mode. There was no sign on the trans going out, just went out on my wife, in the middle of driving. Would another trans computer need to be flased?
|
|
|
|
|
Replying to: cridez (Jan 16, 2009 5:21 pm) Best to get codes pulled directly from TCM to help out in diagnoisis.but sounds like it proply one of the speed sensor but need codes to tell you or just replace them but could be a pump problem or valve body well there lots of pauseable causes. as for tcm from another vehicle you can but a reset or beak in presedure must be done or it could have suttering probs during lock up and same goes if replacing torque convertor and speedometer signal must be recalibrated aswell.
|
|
You are here:
Forums
Vans & Minivans Chrysler Town & Country/Dodge Grand Caravan Chrysler Minivan Transmission Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chrysler Town and Country
2007 Dodge Caravan
2000 Plymouth Voyager
2000 Chrysler Grand Voyager
2010 Dodge Grand Caravan
Browse by Board
Browse by Topic
Today's Chats
