Mazda MPV

8223 messages,  Last post on Dec 14, 2011 at 1:46 PM

You are in the Mazda MPV Forum.

What is this discussion about? Mazda MPV, Van

#8219 of 8223 Re: front end clicking noise [trx9805] by myraven17

Oct 01, 2011 (2:47 pm)

Replying to: trx9805 (Mar 17, 2010 6:41 pm)
The bearings in the wheel hub is bad, you can purchase one for about $40 and have it pressed in and you should be ok after that.

#8220 of 8223 Re: front end clicking noise [myraven17] by buzzk

Oct 01, 2011 (7:21 pm)

Replying to: myraven17 (Oct 01, 2011 2:47 pm)
I'd guess by now the problem is fixed; if not, a worn C-V joint might make a similar sound - usually when turning - more than going straight. The notion of the source being loose sway bar bushings, particularly if associated with hitting bumps, is reasonable. I have a somewhat similar sound in one of my sedans that does apper to be caused by loose sway bar bushings.
 
Cheers, BK

#8221 of 8223 Front end issues and check eng light by tcc21

Oct 01, 2011 (8:49 pm)

I have a 2003 with 160K on her. I've had the check eng. light on issue many times. I use to get it cleared just to be sure there wasn't a new issue but it usually is the "bank 1 misfire - cold startup" issue or the catalytic converter issue.
The front end also was replaced under extended warranty around 95K miles. It was a worn tie rod issue. Yes, you do hold your breath with these things! I also would like to hang onto mine two more years. We'll see.

#8222 of 8223 Trying to resolve P2187 and P2189 codes... by mpv2005

Dec 13, 2011 (11:21 pm)

The Check Engine light on my 2005 MPV with 89K miles, has been coming on. I'm getting either P2187 (System too lean at idle bank 1) or P2189 (System too lean at idle bank 2) codes.
 
I removed the MAFS and sprayed it with electronic contact cleaner, but that did not resolve it.
 
The CE light sometimes turns off by itself, and it is more likely to come back on when the weather is wet. That leads me to think there may be a bad contact somewhere, but if its not the MAFS, what can it be?
 
The engine runs fine; idling, cold-start, acceleration, etc are fine.
 
I'm looking for suggestions on what can be causing the codes before I go to the dealer. Thanks!

#8223 of 8223 Re: Trying to resolve P2187 and P2189 codes... [mpv2005] by jipster

Dec 14, 2011 (1:46 pm)

Replying to: mpv2005 (Dec 13, 2011 11:21 pm)
Oxygen sensors and IAC valve have been known to be problematic in the MPV.
 
CE light in wet weather usually means ignition coils. But, you say van runs fine.
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement