Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Vans & Minivans Chevy Express & GMC Savana Chevy Express/GMC Savana
595 messages, Last post on Aug 14, 2008 at 12:35 PM
You are in the Chevy Express & GMC Savana Forum. Your Host is Karens
|
I think the Chevy Van build quality is very good. I also had a Toyota way back, and I remember the steering rods needed to be replaced, where the joits (AV joints or something like that) had warn down. The Chevy has a grease housing around these joints where as the Toyota and Dodge didn't. I rememeber I could always hear them squeaking in the Toyota and nothing you could do other than spraying them with WD40. The Chevy Express 2000 and 2006 also had galvanized bolts holding a lot of parts together in the foot wells, at the bottom of the doors, and other inside outside places, where as the Dodge and Toyota had ones that rusted in no time flat. The Toyota's AC broke, curze control, and a lot of other little things. The Dodge was just a nightmare from day one. The Chevy 2000 2500 had only a few minor problems with the door locks, one of the doors wasn't hung right and another back latch broke, and the gas gage broke, and it may have developed a slight leak in the radiator, I had to add about a half gallon a year at the end, and should have had it checked (make sure to keep it filled! And change it at about 35,000 miles if you need to.) But that was it, and I didn't even have any of this repaired. I hope the 06 Express holds up as well or better. |
|
|
|
|
Replying to: johnsc (Aug 26, 2007 1:27 pm) Thanks for all everyone's suggestions ... |
|
|
|
| Hi! Does anyone know if GM is going to install engines with valve deactivation on Express? It can really help highway mileage. | |
|
|
Does anyone have an '08 Express or Savana 12 passengers. I want to know whether the four-person bench can be split. The picture on Chevy website seems to show some sort of line down the middle of the four-person bench but there is no description anywhere on the 'splitability" or "foldable" of this bench. Thanks
|
|
|
It comes and goes. In summer, when cold, it would start and stall. Each time it would run longer. I could feather it to get it running better...When I tried to drive it, same... wanted to stall... I feathered it. Went away when warm. Then, it vanished for a while. IT's back and it's way colder and now it fires for a second and stalls. Can't get it going now....... ????????? R/T |
|
|
Replying to: eandlcubed (Nov 20, 2007 6:35 pm) |
|
|
|
|
Hi all, I'm working on a 2004 Chevy Express 3500, and the instrument panel gauges have died. When the car starts up, the arrows wiggle a little, and the alternator gauge goes to normal, then they all quit. the panel still lights up, and shows the prnd, but no little underline bar to tell you what gear you're in, and the odometer is no longer adding miles. The check gauges light comes on, but I have yet to find the problem. All fuses, both under the seat and in the engine, look good. Is there a connection in the dashboard or something that might be loose? they are obviously getting power, just not functioning right, or poorly. An item that may or may not be related, is the reverse lights on the rear aren't turning on, and quit at the same time as the gauges. Thanks, Ryan |
|
|
|
| I have a 1999 2500 cargo van with 400,472 miles on a 5.0L motor. At times it wont accelerate and has a bad hesitation. Then out of no where it runs great! Installed new plugs, wires, pcv, rotor, cap, tps, fuel filter, and checked timing chain. It is putting out over 50psi of fuel pressure. I pulled wires with it running and noticed that one time when it was doing this the whole left side of the motor wasn't firing, but then it was great. Might it be the injectors? | |
|
Now I know I'm a woman but give me a break...the instructions on how to remove the right taillight cover to replace the bulb are ridiculous! I have the nuts removed and can barely pull the assembly to clear the studs but now I'm supposed to "turn the side assembly on the outboard side, releasing the upper clip". I have been pulling and wrenching that thing in all different directions and it isn't budging an inch!! Can someone give me a clue as to what I need to do before I just break it open. Thanks, BJ
|
|
|
Replying to: momto7 (Mar 02, 2008 4:14 pm) |
|
You are here:
Forums
Vans & Minivans Chevy Express & GMC Savana Chevy Express/GMC Savana
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2009 Chevrolet Express
2009 GMC Savana
2009 Chevrolet Express Cargo
1996 Chevrolet Sportvan
1998 Chevrolet Chevy Van
1996 Chevrolet Chevy Van Classic
Browse by Board
Browse by Topic
Today's Chats
