You are here: Forums Vans & Minivans Chevy Express & GMC Savana Chevy Express/GMC Savana

Chevy Express/GMC Savana

618 messages,  Last post on Oct 31, 2009 at 12:44 PM

You are in the Chevy Express & GMC Savana Forum. Your Host is Karens

What is this discussion about? Chevrolet Express, GMC Savana, Chevrolet Express Cargo, Chevrolet Sportvan, Chevrolet Chevy Van, Chevrolet Chevy Van Classic, Van

#411 of 618 fuel pump problems by neon Jun 28, 2005 (6:30 pm)
I have a '99 Express with 96000 miles, I replaced spurk plugs, cables, rotor, rotor cap, fuel filter, oil, oil filter. Water pump not long ago. The van was giving me problem to start, I thouthg I fixed the problem after replacing all of the above, but the van didn't start. someone told me it was the fuel pump, I purchase a pump from the dealer ($460) and the van starts but it jerks a little, when in idle, the engine doesn't run smooth. the ride is ok, but not like before, especially when going up hill. The problem can be notice also when going in reverse. After spending a lot of money, and time, I'm not please with the results. Dealer couldn't find the problem either. please help me. Replies to this message: flybaby (Jun 30, 2005 4:39 am)
#412 of 618 ERRATIC FUEL GAUGE by sherrodman Jun 29, 2005 (7:59 pm)
MY 1997 CHEVY VAN 5.7 VORTEC G10 HAS HAD AN ERRATIC FUEL GAUGE SINCE DAY ONE. I HAVE REPLACED THE FUEL SENDING UNIT, FUEL PUMP AND INST CLUSTER WITH NO LUCK. MECHANIC HAD TO MANUALLY ADD/CHANGE RESISTANCE OF FEED WIRE TO GAUGE, BUT DID NOT OR COULD NOT CALIBRATE CORRECTLY. THE GAUGE READS FULL WHEN FULL BUT READS ALMOST 1/4 TANK WHEN RUNS EMPTY. CAN I ALSO MANUALLY PUT A VARIABLE POT-METER TO GET A PRECISE RESISTANCE TO SEE IF GAUGE CALIBRATES WITH THE NEW RESISITANCE ADDED OR SHOULD I CONTINUE TO GO TO BED WITH MY ODOMETER READINGS AND HOPE I DON'T DREAM THEM AWAY? THANKS. PS-I CAN'T FIND IF MY VAN IS RWLD OR 4WLD--HELP? Replies to this message: claires (Jun 30, 2005 7:06 am)
#413 of 618 Re: fuel pump problems [neon] by flybaby Jun 30, 2005 (4:39 am)
Replying to: neon (Jun 28, 2005 6:30 pm) hi there, I have had kind of the same problem, i checked the PCP valve on the top of the rocker cover this was sticking so i replaced it ! you can tell if its sticking as it doesnt rattle, it should ! then it runs smooth again. hope it helps
#414 of 618 Re: ERRATIC FUEL GAUGE [sherrodman] by claires HOST Jun 30, 2005 (7:06 am)
Replying to: sherrodman (Jun 29, 2005 7:59 pm) Welcome to the Forums, sherrodman! You might also want to post your question in the Got a Quick, Technical Question? discussion. By the way, it's a good idea to take your caps lock button off -- when you type in all caps, readers might think you're shouting at them
#415 of 618 Re: Shocks [wlunsford] by judge5 Jul 01, 2005 (6:57 am)
Replying to: wlunsford (Dec 06, 2002 7:34 pm) Hello, I own a 1997 2500 12 passenger Express van. Technically it is the same as the 2000. I tried every possible shock brand out there and believe it or not the best results I got were from KYB shocks, the series is GAS A JUST. I was very skeptical about using Japanese shocks on my van, but once I tried them, believe me I was amazed at the smooth ride and stability. I tried, Monroe Gas Magnum and the ride was back braking, too hard. I tried Gabriels and too soft. I even went with the very expensive Rancho RS9000X and they were either too soft or too hard, could not find a comfortable setting out of 9 they have. Finally a friend told me that his montero improved ride and stability with these KBY Gas A Just shocks, so I decided to spend an other $ 150.00 for the set and these were the best $150.00 I put into my van.          For even more stability, if needed, I changed the rims on my van for a set of 2003 Dodge Ram 8lug mag wheels, which by the way look awesome, can send you pics if you want. I got the wheels from ebay, when they arrived, I put one on in the front driver's side and found that the wheels were too wide on the inside so the steering arm was touching the wheel and could not use these rims, I liked the rims so much that I decided to buy a set of spacers to be able to install them. I got a set of 2" spacers, but 1" would have been enough to space the wheels. Now the Van looks great and I have even more stability when cornering.          Hope I have been helpful. Take care, Judge5
#417 of 618 How do you remove arm rests? by boda2 Jul 09, 2005 (3:58 am)
I have a new 2005 Chevy Express passenger van. How do you remove the arm rests from the front seats? I'd like to install seat covers.
#419 of 618 2000 express starting problem by chapin1 Jul 16, 2005 (9:27 am)
my trouble is that my van will start and run for 2 seconds then die,i got a scanner and it says "pass" no codes what could it be?
#420 of 618 GMC Savana Van 2004 Vibration Problem by catlady Jul 17, 2005 (9:54 am)
Has anyone with 2004 GMC Savana Van experienced extreme vibration and shaking with loss of power while driving on highway at 60 to 70 mph? Shaking may continue for 5 minutes, as we always try to pull off when condition occurs. After we shut down , we can then resume trip and vibration may not occur for 20 miles or maybe 800 miles. Dealerships have not been able to find problem. If anyone has any info on this I would appreciate to hear from them. Replies to this message: bhew (Apr 12, 2006 9:44 am)

You are here: Forums Vans & Minivans Chevy Express & GMC Savana Chevy Express/GMC Savana