You are here: Forums Vans & Minivans Chrysler/Plymouth Voyager, Dodge Caravan Dodge/Plymouth/Chrysler Minivan Problems & Solutions 

Dodge/Plymouth/Chrysler Minivan Problems & Solutions - READ ONLY

4276 messages,  Last post on Oct 23, 2006 at 1:11 AM

You are in the Chrysler/Plymouth Voyager, Dodge Caravan Forum. Your Host is Karens

What is this discussion about? Dodge Caravan, Dodge Grand Caravan, Chrysler Voyager, Plymouth Voyager, Chrysler Town and Country, Van

#4067 of 4276 Re: 01 Caravan Won't Start [98tclxi] by leesprts31 Jun 30, 2006 (8:56 pm)
Replying to: 98tclxi (Jun 30, 2006 7:31 pm) Yes, I have a Security System - The repair shop thought that the malfunction was asociated with this, but was unable to determine where, suggested I take to dealership, but they can't fit me in for about a week, need vehicle before then! Replies to this message: lengene (Jul 18, 2006 11:04 am)
#4068 of 4276 02 GC Check Engine Light by danieldkk Jun 30, 2006 (9:42 pm)
My 02 GC with 42K miles has a check engine light come on. My local Goodyear repair shop checked it and cleared it. It came back on after about 100 miles. Anyone have similar problem? Replies to this message: mikew58 (Jul 01, 2006 6:57 am) danieldkk (Jul 01, 2006 7:59 am) mfahey1 (Jul 01, 2006 2:50 pm) and 2 more...
#4069 of 4276 Re: 02 GC Check Engine Light [danieldkk] by mikew58 Jul 01, 2006 (6:57 am)
Replying to: danieldkk (Jun 30, 2006 9:42 pm) Yep, been there done that. The fault that is causing the light to come on is still there. Try turning the ignition to the on position, all the way till the dash warning lights come on but before it starts. Do this in the following pattern - on - off - on - off - on then watch the odometer and you will get a trouble code. It will start with a P------- tell us what you get and perhaps we can ID the source of the fault. You will have to get whatever is not working fixed inorder for the light to stay off. Replies to this message: danieldkk (Jul 01, 2006 7:59 am) mfahey1 (Jul 01, 2006 2:50 pm) danieldkk (Jul 08, 2006 8:43 pm) and 1 more...
#4070 of 4276 Re: 02 GC Check Engine Light [mikew58] by danieldkk Jul 01, 2006 (7:59 am)
Replying to: mikew58 (Jul 01, 2006 6:57 am) Codes are P1684, P0442, and P0455. I went to Allpar.com and found they are "Driver 5 Line 4", "Evap system smalll leak detected", and "Evap system leak detected".But what do these mean? Replies to this message: mfahey1 (Jul 01, 2006 2:50 pm) danieldkk (Jul 08, 2006 8:43 pm) mfahey1 (Jul 10, 2006 4:45 pm)
#4071 of 4276 Re: 02 GC Check Engine Light [danieldkk] by mfahey1 Jul 01, 2006 (2:50 pm)
Replying to: danieldkk (Jul 01, 2006 7:59 am) I just had this fixed on our 2001. There was a cracked line going to the charcoal cannister. Whether this is your problem or not, the codes indicate a malfunction of the evaporative control system. There are a variety of possible sources of the problem but if you are looking to do it yourself, do a visual check from underneath to see if anything is broken, disconnected or cracked. Replies to this message: danieldkk (Jul 08, 2006 8:43 pm) mfahey1 (Jul 10, 2006 4:45 pm)
#4072 of 4276 charge air temp. sensor by larry63r Jul 02, 2006 (3:55 pm)
Where is this sensor on a "94" 3.3 DGC? My book says I have one, but I can't find it.
#4073 of 4276 Separate balljoint from knuckle... by amazon Jul 06, 2006 (5:49 pm)
I'm replacing the driveshaft on my '94 voyager. The problem is, the balljoint is stuck in the knuckle. The clamp bolt has been removed, the sway bar has been loosened, but the ball joint won't budge.   Any ideas? Replies to this message: mfahey1 (Jul 07, 2006 12:04 pm) amazon (Jul 07, 2006 7:08 pm)
#4074 of 4276 Re: Separate balljoint from knuckle... [amazon] by mfahey1 Jul 07, 2006 (12:04 pm)
Replying to: amazon (Jul 06, 2006 5:49 pm) There are relatively simple tools to do the removal but I've had good luck with an ordinary propane torch and a hammer or better yet, a small sledge hammer. Heat around the knuckle and it should expand enough that a tap of the hammer will release it. Replies to this message: amazon (Jul 07, 2006 7:08 pm)
#4075 of 4276 Re: Separate balljoint from knuckle... [mfahey1] by amazon Jul 07, 2006 (7:08 pm)
Replying to: mfahey1 (Jul 07, 2006 12:04 pm) Thanks for the idea. I got it out by turning the "pin" around with pliers, and then use a crow bar to separate the control arm from the knuckle.
#4076 of 4276 91 caravan will not start by gambitt01 Jul 08, 2006 (10:13 am)
new to this forum. I have a 91 dodge caravan that will not start. It is not gettind spark and no fuel. someone told me of a sensor that tells the engine when it needs spark and fuel but i need to know the name of the part/parts and where they are on the engine i also have a 89 plymonth voyager and need to know if those sensors are interchangeable with the 91.....thanks

You are here: Forums Vans & Minivans Chrysler/Plymouth Voyager, Dodge Caravan Dodge/Plymouth/Chrysler Minivan Problems & Solutions