You are here: Forums Vans & Minivans Nissan Quest Nissan Quest/Mercury Villager problems 

Nissan Quest/Mercury Villager problems - READ ONLY

2519 messages,  Last post on Oct 23, 2006 at 1:23 AM

You are in the Nissan Quest Forum. Your Host is Karens

What is this discussion about? Nissan Quest, Mercury Villager, Van

Messages Page 252 of 252 1 ... 246 247 248 249 250 251 252 Prev Next Last

Go To Msg # Search This Discussion

#2510 of 2519 Shoulder belt locks in open position - How fix? by gallilaw Oct 01, 2006 (1:19 pm)
Sometimes the "automatic" shoulder belt on my 1994 Villager will lock in the open position. Jiggling, bouncing, pressing buttons, tugging... nothing gets it to slide back where it should be when the car is moving.   Then, a few minutes or hours or days later it will start working normally again.   Please help me trouble-shoot and fix this problem.   Thanks.
#2511 of 2519 99 Villager brake light problems by shazu Oct 02, 2006 (2:14 pm)
I have 2 problems... First, when I press on the brake, the radio lights dim and the thermostat degrees display goes out completely. The dash lights are ok. When I release the brakes, the lights are bright like normal.   2nd problem:   My 99 Villager had a brake light out. We replaced the light bulb but it still only works if we hold the bulb in. Once we put the light back together it is out again. There is a recall on light sockets in the 99 Villager but my VIN # wasn't part of the recall. Anyone know where I can get a replacement socket so we can replace it?   Any help is appreciated. Shannon Replies to this message: kw_da (Oct 04, 2006 10:33 pm)
#2512 of 2519 Re: 99 Villager brake light problems [shazu] by kw_da Oct 04, 2006 (10:33 pm)
Replying to: shazu (Oct 02, 2006 2:14 pm) Hi,   Since noone else answered, I can take a stab. It appears your problems may be related. It looks like there is a short in your brake light, when you press the brake, power is sent to the brake light which then shorts to ground, which then lowers the voltage on the circuit so the other lights go out. However, in looking at the electrical circuits, it doesn't appear that the radio lights & thermostat lights are on the same circuit as the brake. I'd replace the broken brake light harness and see if the problem goes away.   Try this site for ordering parts forpartsonline.com . I've ordered here and they appear to be much cheaper than the dealer, even including shipping. You may want to check with your local dealer anyway.   Good Luck,   David
#2513 of 2519 Code on 95 by scottmsimpson Oct 05, 2006 (5:17 pm)
We used to have a 95 Villager. I took it to AutoZone a few years ago when the Check Engine light was coming on intermittantly. Their code reader was for OBD2 vehicles, which started at the 96 model year. So, they could not read any codes from it. There was either no connector, or it was the wrong type, I don't remember.
#2514 of 2519 2000 Villager- rear AC issue... by sarinaz Oct 14, 2006 (5:40 am)
Hello to all;   Wife and I bought 2000 Villager, 57k miles. Great vehicle. All works well, except rear ac blows warm and fan switch above 2nd seat row doesn't function. Front panel switch wroks, air blows ice cold up front. I have reviwed several posts, nothing seems to match my exact problem. Thanks! Replies to this message: steve_ (Oct 14, 2006 8:13 am)
#2515 of 2519 Re: 2000 Villager- rear AC issue... [sarinaz] by steve_ HOST Oct 14, 2006 (8:13 am)
Replying to: sarinaz (Oct 14, 2006 5:40 am) Just to clarify, the rear A/C vent is just up top. The bottom vents under the front row seats are just for heat. So if the 2nd row fan isn't working up top, my guess is that the A/C can't get pushed out the upper vent.   Steve, Host SUVs & Speed Shop
#2516 of 2519 Anyone Have Peeling Paint? by kw_da Oct 14, 2006 (10:09 pm)
Hi,   I have a 94 Villager. The paint is peeling off the top. It appears to be worse on the drain channels on either side. The paint is separating from the base coat - it appears that the final paint wasn't well bonded to the primer. Just putting tape on the paint causes it to peel up when you remove the tape. I'm currently trying to reprime & repaint.   Any advice, experiences to share?   Thanks,   David
#2517 of 2519 mercury villager 1995 by sally1964 Oct 17, 2006 (4:23 pm)
I have replaced the thermostat on my van and the top raditor hose is very hot while the hose coming out of the raditor is not so hot, the thermostat is on the passenger side of the van and the other hose is opposite side. someone told me that it might be that my raditor is stopped up. does anyone know what might be the problem.
#2518 of 2519 heater hose, by sally1964 Oct 18, 2006 (10:19 am)
where is the heater hose located. on a 1995 mercury villager van
#2519 of 2519 Nissan Quest/Mercury Villager Problems by claires HOST Oct 23, 2006 (1:23 am)
You may have noticed that we're moving toward smaller, more focused discussions, and a number of those have already been created for this vehicle (e.g., tire issues, starting/stalling problems). Please go to the top level of the board here and look for an existing discussion that fits your question or issue. If you don't see a suitable topic, please feel free to create one. Here's a link: Nissan Quest    Clicking "Track This Group" will make sure that you don't miss any new posts or discussions. When you come back the next time, just click on "Read New Posts" and you'll be able to click through all new posts and topics in this board.

Messages Page 252 of 252 1 ... 246 247 248 249 250 251 252 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Vans & Minivans Nissan Quest Nissan Quest/Mercury Villager problems