You are here: Forums Vans & Minivans Chevy Venture Chevy Venture

Chevy Venture

2455 messages,  Last post on Oct 23, 2009 at 9:27 AM

You are in the Chevy Venture Forum. Your Host is Karens

What is this discussion about? Chevrolet Venture, Van

Messages Page 205 of 246 1 ... 202 203 204 205 206 207 208 ... 246 Prev Next Last

Go To Msg # Search This Discussion

#2039 of 2455 Re: I need help lol [eeyore1] by ronsmith38 Dec 05, 2005 (5:01 am)
Replying to: eeyore1 (Dec 02, 2005 5:29 pm) If it is humming a Looney Toone don't complain. Seriously, it probably is the tires. The tires tend to cup on these vans if not rotated very often. When they are cupped they hum.
#2040 of 2455 Re: 2000 Venture Van Fuel Gauge Not Working [gerry6] by 123venture Dec 05, 2005 (9:01 am)
Replying to: gerry6 (Jul 13, 2005 8:17 am) Where would I find the cable. Can it be accessed without a hoist?
#2041 of 2455 Re: I've replaced my alternator 3 times in the last month! Help!!!! [ts60423] by crackchecker Dec 05, 2005 (9:02 am)
Replying to: ts60423 (Dec 02, 2005 9:27 am) Another thing to look at would be a battery with a internal short. Load test it!!!   My 88 Escort just recently lost the alternator and it was related to the battery going out.
#2043 of 2455 2000 Venture Fuel guage/dome lights/hesitation by 123venture Dec 05, 2005 (12:11 pm)
I'm having problems with my fuel guage moving from empty to full. This normally happens when I'm down to a quarter tank of gas.   Also have no interior lights at all. If I open my doors or use the switch on the dash board there are no lights at all. (Dome light) all other are fine. JUST MY DOME LIGHTS DON'T WORK.   I also have hesitation when I acellerate and can't figure out what it is. Wires have been changed but not the plugs to hard to get at. Any suggestion would be greatly appreciated.   thanks Replies to this message: byker220 (Dec 14, 2005 5:54 am) 123venture (Dec 14, 2005 6:46 am) just4fun2 (Dec 14, 2005 1:10 pm) and 1 more...
#2044 of 2455 Chugging/Hesitation 2000 Venture by 123venture Dec 07, 2005 (5:42 am)
Please read below this is from a previous member and this was how they fixed his problem. I like to find out where I can check for corrosion on the pins where the cable is plugged in that goes to the guage readings on the dash.   Do not let them put in a new sensing guage inside of the fuel tank before they check for corrosion on the pins where a cable is plugged in that goes to the guage readings on the dash. after they cleaned the pins I didnt have any more problems. I learned the hard way because that sensing unit they put in the gas tank cost me about $400 Dollars and I dont think that I needed it.
#2045 of 2455 Re: Aluminum Corrosion [agt_cooper] by rustbucket Dec 07, 2005 (2:38 pm)
Replying to: agt_cooper (May 26, 2005 11:05 am) I'm an automotive corrosion engineer. You're right about galvanic corrosion occurring where you mix steel and aluminum, but that's not what's happening with the hood in this case. The problem on the hood is just corrosion of the aluminum. When steel rusts, it is red. When aluminum rust, it's white/milky. The problem is 'filiform corrosion.' This happens with aluminum that's covered with a paint or other similar coating. When aluminum is exposed to air, it forms a protective alumunium oxide film on the surface (about 1nm thick), which protects the aluminum underneath. When you get a chip in the paint on your aluminum hood, water gets under the chip. The salt/water starts to attack the aluminum. Because it's held in by the paint, it doesn't dry out and have a chance to reform the aluminum oxide.
#2046 of 2455 Re: Chevy Venture Keyless Entry Remotes & Programming Instructions [93miata] by nicholas_e Dec 07, 2005 (7:06 pm)
Replying to: 93miata (Oct 14, 2005 5:01 pm) Just a warning...I ordered two remotes from www.thepartsyouneed.com over a month ago. I have not received them yet. The tracking number shows no useful info. I emailed the site and got no response. I called the phone number on the site a couple of times and there was no answer. I waited a week and emailed again. This time I got a response. But no apology or explanation, no info at all. Just asked me to check the ship address. It was correct. I replied back. That was the last I heard. They charged my credit card immediately, before they supposedly shipped, by the way. Replies to this message: just4fun2 (Dec 07, 2005 7:45 pm) nicholas_e (Dec 11, 2005 4:39 pm)
#2047 of 2455 Re: Chevy Venture Keyless Entry Remotes & Programming Instructions [nicholas_e] by just4fun2 Dec 07, 2005 (7:45 pm)
Replying to: nicholas_e (Dec 07, 2005 7:06 pm) Contact your credit card company explaining the situation to them and ask for help.
#2048 of 2455 Re: 2001 Venture SES light [ts60423] by jsm1a Dec 09, 2005 (6:29 pm)
Replying to: ts60423 (Dec 02, 2005 9:31 am) It turns out there was a dealer bulletin for my year venture. I took it to a dealer to have the PCM reprogrammed to correct false EGR position error.Cost $90. Replies to this message: huney (Jan 26, 2006 3:38 am)

Messages Page 205 of 246 1 ... 202 203 204 205 206 207 208 ... 246 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Vans & Minivans Chevy Venture Chevy Venture