You are here:
Forums
Coupes & Convertibles
Mazda Miata
Mazda MX-5 Miata (2005 and earlier)

4340 messages, Last post on Aug 25, 2009 at 9:51 AM
You are in the Mazda Miata Forum. Your Host is claires
|
Replying to: lsa_1977 (Jun 27, 2008 9:42 am) |
|
|
I have a 1990 MX5 with a new engine. 2500 miles. The oil pressure guage does not show oil pressure till about 2000 rpm then at best only slightly. I know it must be better or I would have motor problem by now. Previous owner installed new motor so I don't know much about the work done. Car runs and performs well. Need a new sender? What should the pressure register? Loren
|
|
|
Replying to: lbound (Jul 20, 2008 10:10 am) Mine reads low until I rev the engine, but not zero, just low. It jumps up when the engine revs, then stays pretty steady and increases slightly with high rpms. |
|
|
|
|
I have an intermittent "squeal" noise when I first start up my '04 Miata, when the engine is cold. It also happens (on ocaision) when I first turn on the a/c ( goes away when turned off ). After about a minute the squeal goes away. I think it is coming from both the a/c and alternator (belts). I haven't driven the car for several months. The drive belts were changed about 10K miles ago. ( Purchased the car about a year ago, but haven't had the chance to drive it much until lately ). Is this common ? Should the belts be adjusted ? Other common causes ? |
|
I recently ordered a replacement headlight switch for my '97 Miata. I am by no means a mechanic! My switch was deemed bad by a professional. I am now facing the task of replacing it. How?! Do I remove the steering column cover or steering wheel? Help! I have no headlights or taillights! And the dash lights aren't working either. Can anyone give me simple directions to replace the switch and come back to the LIGHT!!!! Thx!!!!
|
|
|
Replying to: rwillis2 (Oct 26, 2008 10:05 am) http://www.miata.net/garage/ |
|
| How do I find directions to replace the O2 Sensor on my 2001 Miata? I don't want to have to buy a repair manual just to do this. I'm not mechanically inclined. I have only known how to change oil and filter. I have also heard that I'd need a special tool (crow-feet wrench?). Thanks. -Hieu | |
|
Hello. I just bought a 1992 Mazda Miata. I wanted to know if it has a non-interference engine? I read that the 1991 has a non interference engine but I didn't know if the same applied to the 1992 Miata. I love my little Miata!! I don't know much about them since I have only owned it for 3 days but I am in love with it and I want to keep it forever so that is why I was looking into timing belts and the like. Is changing the timing belt on my 92 difficult? Thanks in advance!
|
|
|
Replying to: beckig (Feb 11, 2009 12:06 pm) I just changed my belt, but I paid a mechanic to do it. I did reset the timing, though, because they got that part wrong. |
|
You are here:
Forums
Coupes & Convertibles
Mazda Miata
Mazda MX-5 Miata (2005 and earlier)
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2005 Toyota MR2 Spyder
2010 Mazda MX-5 Miata



Browse by Board
Browse by Topic
Today's Chats