You are here: Forums Coupes & Convertibles Mazda Miata Mazda MX-5 Miata (2005 and earlier)

Mazda MX-5 Miata (2005 and earlier)

4340 messages,  Last post on Aug 25, 2009 at 9:51 AM

You are in the Mazda Miata Forum. Your Host is claires

What is this discussion about? Mazda, Toyota MR2 Spyder, Mazda MX-5 Miata, Convertible

Messages Page 387 of 435 1 ... 384 385 386 387 388 389 390 ... 435 Prev Next Last

Go To Msg # Search This Discussion

#3859 of 4340 by ateixeira Nov 19, 2004 (7:13 am)
My Robbins top is water tight so far but that wind noise on the driver's side is back again. Not too bad, though.   -juice
#3860 of 4340 by revdrluv Nov 19, 2004 (3:56 pm)
Well I am in Southern California, so not much chance to test the leak in the rain. I have tried pouring water directly on the top, but have so far been unsuccessful in recreating the leak situation. I am guessing at this point that some fool didn't latch the top down fully, or left the windows slightly ajar before the night of that rain storm.   "Next time, I'll get a Robbins top..." What type of top are you currently using? Are you not happy with it?   On my old Miata I replaced the top with a Robbins vinyl top w/ plastic window (for economic reasons) and was very happy with it. Didn't have any problems with rain afterwards, and that was in Savannah. GA, so there was plenty of it around.
#3861 of 4340 revdrluv by thel Nov 20, 2004 (10:29 am)
I obught my top from a fellow member, but the top originally came from this place:   http://aabestco.com/merchant.ihtml?pid=1300&lastcatid=963&amp- ;step=4   And no...I'm not too happy with it. I'd have to say that this is a good example of getting what you pay for.
#3862 of 4340 gas gauge problem? by kaspar10 Nov 21, 2004 (10:24 am)
My gas gauge never reads full, only goes to about 3/4 and stops. As I drive it starts to fall and will read correctly. when I fill up, I estimate how much it should take by the gauge reading and I am within 1/2 gallon of being right, so I am comfortable that it is reading correctly after it starts to fall. Any ideas??? Had my car now for almost a month!!!! '96 standard, 50k miles....geeez life is good!!! I am thinking of getting some braces for under the car and the engine bay and trunk. Will i be able to notice the difference in increased stiffness. Is it worth the money?
#3863 of 4340 thel by lngtonge18 Nov 22, 2004 (6:30 am)
My rear window never leaked. The top pulled away from the bottom of the window a total of maybe 1.5-2" in length and then stopped. I don't think it pulled far enough down to cause a leak. It just spread horizontally. How much has pulled away on your window? I would definitely try putting clear silicon along the bottom of the entire window. Once that stuff sets, it's pretty sticky and should be able to handle the stress of putting the top up and down as well as keep the rain out. Just think, if it does work, you still got a cheap reasonable quality glass window top. Other then the inferior glue they used around the window, the top seems pretty good. However, I feel really bad that I ever sold the darn thing because it was never my intention to aggravate another good member on here. I'm sorry it's been a problem for you. I was hoping the first top was a fluke, but I guess that's not the case. Maybe you could email the company and ask them what they suggest to fix it, not to mention complain to them about the crap glue they are using!   I no longer own the Miata as I have since sold it and then bought a 90 RX7 convertible to take its place (thankfully the top was replaced before I bought it and is of very high quality!). Good luck and let me know if the silicone stops the leak.
#3864 of 4340 by ateixeira Nov 22, 2004 (7:49 am)
I think they made the rear brace standard in '93 (I have it), and the front brace in '94. Yours might already have both. I'm talking on the under side.   You can add the spring tower braces front and rear and expect incremental improvements. I have the front spring tower brace and a home-made brace on the under side of my '93.   -juice
#3865 of 4340 Ingtonge18 by thel Nov 22, 2004 (9:33 am)
No hard feelings towards you at all. Frankly, the price we agreed to is indicitive of the value of the top so I don't feel ripped off at all.   I'm just having some trouble with it and I was wondering if you had the same trouble, and if so, what you ahd done that helped or hurt. That's all. I'll try the silicone solution and see how it goes.
#3866 of 4340 Seat covers by thel Nov 28, 2004 (9:44 am)
Anyone had good luck with any cheapo seat covers? I'm thinking sub $40-50 range. Any more and I'll just take the time to reupholster them myself. My seats have some rips in them in of all places the very tops of the head rests.
#3867 of 4340 by ateixeira Nov 29, 2004 (7:38 am)
Did you roll it at an autocross? :o)   -juice
#3868 of 4340 I don't autocross by thel Nov 29, 2004 (7:44 am)
Nowhere around here has events...that I know of anyway. Honestly, I bought the car with the headrests ripped...really the only rough part of the interior. I have no idea how it happened to either one of them, much less both of them.

Messages Page 387 of 435 1 ... 384 385 386 387 388 389 390 ... 435 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Coupes & Convertibles Mazda Miata Mazda MX-5 Miata (2005 and earlier)